User Manual
Table Of Contents
- Table of Contents
- Safety Instructions
- Copyright
- Trademarks
- Introduction
- Features
- Package contents
- System requirement
- Product overview
- Connection
- DIN mounting kit installation
- Pin assignment
- Using SEC (Serial-to-Ethernet Connector)
- Quick starting guide
- Serial to Ethernet Toolkit
- Web console
- Telnet console
- Regulatory compliance
- Specification
61
4-0. Real com mode
1. Real com mode is set with “0”…. Following screen
appears while entering into Real Com Mode.
By default, operating mode for all ports is Real Com
Mode.
2. Type <2> to set TCP Alive check time from the range
(0-99 min). By default its value is 7 mins.
3. Type <3> to congure settings apply to all ports.
4. Type <v> to view the settings made in Real Com mode
as below.
5. Type <m> to go back to the previous screen. If any
option in Operating Port Settings page was congured,
telnet console will ask to save settings. Type <1> to save
changes or Type <0> to quit without saving.