User Manual
Table Of Contents
- Table of Contents
- Safety Instructions
- Copyright
- Trademarks
- Introduction
- Features
- Package contents
- System requirement
- Product overview
- Connection
- DIN mounting kit installation
- Pin assignment
- Using SEC (Serial-to-Ethernet Connector)
- Quick starting guide
- Serial to Ethernet Toolkit
- Web console
- Telnet console
- Regulatory compliance
- Specification
65
5. Type <5 / 7 / 9 / b> to set the Destination Port 1 / 2 / 3 /
4 from the range (0-65535). By default its value is 4001.
6. Type <c> to set the TCP Connect ON Mode. Type
<0> to select Start up mode or Type <1> to select Any
Character mode. By default the Connect ON Mode is
Start up.
7. Type <d> to congure settings apply to all ports.
8. Type <v> to view settings made in TCP Client Mode as
below.
9. Type <m> to go back to previous screen. If any option
in Operating Port Settings page was congured, telnet
console will ask to save settings. Type <1> to save
changes or type <0> to quit without saving.