User Manual
Table Of Contents
- Table of Contents
- Safety Instructions
- Copyright
- Trademarks
- Introduction
- Features
- Package contents
- System requirement
- Product overview
- Connection
- DIN mounting kit installation
- Pin assignment
- Using SEC (Serial-to-Ethernet Connector)
- Quick starting guide
- Serial to Ethernet Toolkit
- Web console
- Telnet console
- Regulatory compliance
- Specification
66
4-3 UDP Client/Server Mode
1. Real com mode is set with “3”…. Following screen
appears while entering into UDP Client/Server Mode.
2. Type <2 / 5 / 8 / b> to set Destination IP End Address 1
/ 2 / 3 / 4.
3. Type <3 / 6 / 9 / c> to set Destination IP End Address 1
/ 2 / 3 / 4.
4. Type <4 / 7 / a / d> to set Destination Port 1 / 2 / 3 / 4
from the range (0-65535). By default its value is 4001.