User Manual
Table Of Contents
- Table of Contents
- Safety Instructions
- Copyright
- Trademarks
- Introduction
- Features
- Package contents
- System requirement
- Product overview
- Connection
- DIN mounting kit installation
- Pin assignment
- Using SEC (Serial-to-Ethernet Connector)
- Quick starting guide
- Serial to Ethernet Toolkit
- Web console
- Telnet console
- Regulatory compliance
- Specification
67
5. Type <e> to set Local Listen Port from the range
(0-65535). By default its value is 4001.
6. Type <f> to congure settings apply to all ports.
7. Type <v> to view the settings made to UDP Client/
Server Mode as below.
8. Type <m> to go back to the previous screen. If any option
in Operating Port Settings page was congured, Telnet
Console will ask to save Settings. Type <1> to save
changes or Type <0> to quit without saving. Again type
<m> to go back to Main Menu.