Power Switch User’s Manual
ABOUT THIS MANUAL This manual is designed for use with the Power Switch. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice.
Table of Contents 1. Introduction ............................................................................................................1 Features..............................................................................................................2 Package Contents...............................................................................................2 LED Indicator ......................................................................................................2 Z-Wave .........
1. Introduction The Power Switch allows you to turn on/off the attached appliance, electronic device or lamp wirelessly by using Z-Wave protocol remote control. You can control the attached load in your home through PC connectivity with a Z-Wave USB dongle when you are away from home.ʳ ʳ ʳ ʳ ʳʳʳ Note: To avoid any dangerous accident, please don’t use this product on the plug of extended power line or else instead of wall plug.
Features Simple plug and play installation. Support electronic appliance or lamp with maximum loading of 1500W Stand-by power consumption: 0.6 W Control On/Off function manually with knob button or remote control by PC equipped with Z-Wave certified USB dongle. Fully compatible with Z-Wave enabled network and capable of communicating with any Z-Wave certified device. All products other then the Power Switch itself are sold separately.
Wireless Range The Power Switch is made wireless by Z-Wave technology. Typical range for a wireless module is approximately 100 feet. When installing the module consider an open area with little obstruction for the best signal and performance. Avoiding the obstruction between the module and controller may make a negative effect on wireless performance and range.
2.
Product Description Below is a description of button, light and plugs for the Power Switch. Z-Wave Enable Outlet This outlet is a socket where the device or equipment you wish to control should plug into, such as LCD monitor. Note that any device plugged into this outlet must NOT exceed 1500 watts. LED The light will blink to indicate that the module has been entered “Program Mode” or when it is communicating wirelessly to the Z-Wave controller (i.e. Z-Wave Dongle).
Installing the Power Switch NOTE ======================================================= Before you install or use this Power Switch, please install your Z-Wave controller first and make an inclusion for your Z-Wave device. Not all Z-Wave enabled remote controls have the same installation process. Actual instructions may vary; it depends on the software that Z-Wave controller provided. ============================================================ 1.
3. Specifications Item Description Protocol Z-Wave (Binary Switch Command Class) Frequency 908.42MHZ( US) Transceiver Yes Operating Voltage AC110~120V/60Hz Max Loading 1500W Stand-by power consumption 0.6 W Green :Z-Wave RF transfer or receive LED Indicator Red : Power Switch power on Switch On / Off (Side Knob Button) Data Rate Up to 40 kbps Operation Range Up to 100 feets Application Indoor use Operation temperature: 10 ~ 40 ̓C Working Environment Storage temperature: -10 ~ 80 ̓C 67.
4. Regulatory Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
