User's Manual

Installing the Power Monitor
NOTE =======================================================
Before you install or use this Power Monitor, please install your Z-Wave

controller first and make an inclusion for your Z-Wave

device. Not all
Z-Wave

enabled remote controls have the same installation process. Actual
instructions may vary; it depends on the software that Z-Wave

controller
provided.
============================================================
1. Please plug the Power Monitor into an available wall outlet in your
desired location of your office or home.
2. Operate your control panel from Z-Wave

controller to include the Z-Wave

device in your network.
3. Once the Power Monitor has been included in your network, you may see or
get some information about the Power Monitor on your control panel or
else to confirm that has been added. If not, try the process again or try
deleting this Power Monitor from Z-Wave

controller first and include
again.
4. When the Power Monitor has been added into Z-Wave

control panel
successfully, you will control this Power Monitor by configuring it to a specific
button or other else on your control panel. Refer to your Z-Wave

control
panel for instructions on how to do this.
5. Now you can plug the electric appliance that you desire to detect the electric
current, voltage, watt or frequency into the Z-Wave

enabled outlet on the
Power Monitor.
5