User's Manual

3. Establishing the Connection
3. Establishing the Connection
Before you start to use the phone, you should first establish the link between the
wireless phone and the dongle. The procedures are as follows:
Step 1. Ensure the link status on the host computer.
Make sure that both SkyWin and Skype are active on your host computer and the
USB dongle is properly plugged.
Before using the wireless phone, always make sure the link between the USB
dongle, SkyWin and Skype is properly established on your host computer. Placing
the cursor over SkyWin systray icon provides you with the communication status as
described in the table below.
SkyWin Icon Link Status
The USB dongle is plugged. SkyWin and Skype are active. The
link is ready now.
The USB dongle is un-plugged or not properly plugged.
Action: Make sure the USB dongle is properly plugged.
Skype is not active or accidentally terminated or SkyWin is not
allowed to access Skype.
Action: Launch and log in to Skype and allow SkyWin to access
Skype.
Skype is not installed on your computer.
Action: Install Skype on your computer.
Step 2. Power on the Wireless Phone Handset.
To power on the wireless phone, long press the Power key until the main screen
appears on the display.
11