User's Manual

Wireless USB Phone User’s Manual
When starting up your wireless phone, the signal indicator and PC indicator
should be displayed on the wireless phone’s LCD. Your Skype name and the time
of the computer plugged with the dongle should also be displayed.
The and indicators disappeared ?
The and indicators will disappear in standby mode. If not operated for 20
seconds, the wireless phone automatically enters standby mode and the RF iink
is temporarily disconnected.
To resume from standby mode, just press the OK key on the wireless phone.
The RF link will be re-established and the indicators should appear again.
Verifying the Link Status via the LCD
The wireless phone LCD will also display related messages if the communication
cannot be established. The following table lists possible screens you will see. Refer
to the table to verify the link status and take required action.
Wireless Phone Display Link Status
The RF link is established and everything is OK. The wireless
phone successfully loads Skype data via the activated
SkyWin.
You are ready to use the wireless phone.
No RF link. The wireless phone cannot find the dongle at
startup.
Action:
y It could be the signal is too weak. Move closer to the dongle
until the signal indicator appears.
y Ensure USB dongle is plugged.
y Make sure the host computer is not in standby or hibernation
mode.
12