Installation Guide

ManualsBrandsGoodman ManualsCooling & Air Quality80,000 BTU 80% AFUE Multi-Speed Two Stage Gas Furnace Low NOx California Model - Upflow/Horizontal

Air Cleaner Installation

Location

Maximum

Heating Airflow

Filter (Media)

Dimensions

Part Number

Air Cleaner

Family

Si de or bottom return 1200 CFM 16 i n X 20 in x 5¼" AM11-1620-5

Si de or bottom return 1600 CFM 16 i n X 25 in x 5¼" AM11-1625-5

Si de or bottom return 1600 CFM 20 i n X 20 in x 5¼" AM11-2020-5

Si de or bottom return 2000 CFM 20 i n X 25 in x 5¼" AM11-2025-5

Si de re turn

(for 2 separate returns )

Si de return (Ri ght angl e) 2000 CFM 20 i n X 25 in x 5¼" AM11-2025-5RA

AM11-5RA

Bottom return (pl a tform) 2000 CFM 20 i n X 25 in x 5¼" AM11-2832-5PP

Bottom return (pl a tform) 2000 CFM 20 i n X 25 in x 5¼" AM11-2843-5PP

AM11-5PP

AM11-5

2 X 1600 CFM

2, 16 i n X 25 in x 5¼"

AM11-3225-5

AM11-3225

AM11-5 AM11-5RA AM11-5PP

Family Family Family

FURNACE STARTUP

1. Close the manual gas shutoff valve external to the furnace.

2. Turn off the electrical power to the furnace.

3. Set the room thermostat to the lowest possible setting.

4. Remove the burner compartment door.

NOTE: This furnace is equipped with an ignition device which

automatically lights the burner. Do not try to light the burner

by hand.

5. Move the furnace gas valve manual control to the OFF

position.

6. Wait ﬁ ve minutes then smell for gas. Be sure check near

the ﬂ oor as some types of gas are heavier than air.

7. If you smell gas after ﬁ ve minutes, immediately follow

the safety instructions in the Safety Considerations on

page 3 of this manual. If you do not smell gas after ﬁ ve

minutes, move the furnace gas valve manual control to

the ON position.

8. Replace the burner compartment door.

9. Open the manual gas shutoff valve external to the furnace.

10. Turn on the electrical power to the furnace.

11. Adjust the thermostat to a setting above room temperature.

12. After the burners are lit, set the thermostat to desired

temperature.

FURNACE SHUTDOWN

1. Set the thermostat to the lowest setting.

The integrated control will close the gas valve and

extinguish ﬂ ame. Following a 15 second delay, the induced

draft blower will be de-energized. After the blower off delay

time expires, the blower de-energizes.

2. Remove the burner compartment door and move the

furnace gas valve manual control to the OFF position.

3. Close the manual gas shutoff valve external to the

furnace.

4. Replace the burner compartment door.