Install Instructions

ManualsBrandsGOODMAN ManualsForced Air Furnaces96% AFUE 120,000 BTU Multi Positional 2-Stage Variable Speed Natural Gas Furnace with 24.5 in. Cabinet

single-stage 24VAC thermostat can be used. For proper op-

eration the thermostat must be setup to control a single-

stage AC outdoor unit and to control a single stage gas fur-

nace. The control board does not accommodate an O wire

thermostat input (reversing valve signal). If a heat pump is

installed, the thermostat should be setup as stated above.

Setting the thermostat for the heat pump control or multi

stage control may result in incorrect performance.

1) Connect all necessary thermostat wires to the

thermostat connector on the furnace control as

instructed by the applicable wiring diagrams shown

in this section.

2) Connect the 1 & 2 wires between the indoor and

outdoor unit for communicating operation.

Note: verify two stage outdoor units include a 24

VAC transformer (for outdoor control board power)

Two stage outdoor units may not behave properly

without this 24 VAC transformer.

Optional

Optional if

feature

supported by

thermostat

INDOOR

BOARD TERMINAL

CONNECTIONS

OUTDOOR

BOARD TERMINAL

CONNECTIONS

OUTDOOR

TRANSFORMER

Communicating Two Stage Air Conditioner or Heat Pump

Figure 49

Optional

INDOOR

BOARD TERMINAL

CONNECTIONS

OUTDOOR

BOARD TERMINAL

CONNECTIONS

24 VAC

Thermostat

Communicating Inverter Air Conditioner or Heat Pump

Figure 50

3) Download the Cool Cloud HVAC phone application

for charging and to configure/test system

operations.

NOTE: When new versions of Bluetooth Communication

Software and Furnace Control Software are available, the

phone application notifies the user. Software updates are

classified as either optional or mandatory and installed by

using the phone application. Ensure all mandatory software

updates have been installed. Review notes for optional

software updates and install if necessary.

Note: If an E11 code exists for the inverter system (shown in

the Cool Cloud HVAC phone application or displayed on the

inverter control), the system verification test needs to be

completed before any other operation. See the folowing

procedure.

1) Allow the system to remain idle for 5 minutes.

2) Turn the system verification test on either by using

the phone application or by entering the  menu

through the furnace push buttons.

3) Wait for the test to complete.

Charging

1) Inverter units using the Cool Cloud HVAC phone

application or control board push button:

a. Inverter units are charged by setting

the  menu (Charge Mode) to ON through

the furnace control board push buttons or

through the Cool Cloud HVAC phone

application.

b. The System will remain in charge mode (high

speed) for 60 minutes before timing out.

c. The installer must manually shut off charge

mode once complete.

2) Two-stage outdoor units using the Cool Cloud HVAC

application:

a. Using the cooling icon after entering the

outdoor unit menus, energize the outdoor

unit at 100% capacity.

b. Charge the outdoor unit as required using

the charging information provided with the

outdoor equipment.

Gas Furnace Testing

1) Two-stage Operation using the Cool Cloud HVAC

application:

a. Select the gas heat icon after entering the

furnace menus.

b. Select any value less than 50% for low

stage operation and any value greater than

50% for high stage operation.

4) Confirm thermostat heating and cooling calls function

proprly with equipment.