GPD14 User's Manual

12
SAFETY LABELS
A. This appliance does not have a pilot. It
is equipped with an ignition device which
try to light the burners by hand.
automatically lights the burners. Do n
ot
the appliance area for gas. Be sure to
smell next to the floor because some gas
is heavier than air and will settle on the
do not use any telephone in your
Do not touch any electric switch;
Do not try to light any appliance.
WHAT TO DO IF YOU SMELL GAS
the gas suppliers instructions.
from a neighbor's phone. Follow
Immediately call your gas supplier
1. STOP! Read the safety information
2. Set the thermostat to lowest setting.
4. This appliance is equipped with an
automatic ignition system which
3. Turn off all electric power to the
6. Move the gas control switch or knob
5. Remove control access panel.
automatically lights the burners. Do n
ot
trytolighttheburnersbyhand.
B. BEFORE OPERATING smell all around
FORYOUR SAFETY READ BEFORE OPERATING
SWITCH SHOWN
IN "ON" POSITION
GAS CONTROL
3. Remove control access panel.
appliance if service is to be performed.
2. Turn off all electric power to the
or any other appliance.
FOR YOUR SAFETY
1. Set the thermostat to its lowest setting.
TOTURN OFF GAS TO APPLIANCE
other flammablevaporsandliquidsin thevicinity of this
to "OFF".
above on this label.
appliance.
building.
floor.
instructions, this
setting.
Do not store or use gasoline or
4. Move the gas control switch or knob
follow the instructions "To Turn Off Gas
5. Replace control access panel.
To Appliance" and call your service
12. If the appliance will not operate,
to "OFF". Do not force.
technician or gas supplier.
in fuel combustion
you to substances
death or serious
which can cause
illness and which
cause cancer, birth
defects or other
reproductive harm.
are known to the
This product contains
fiberglass insulation.
State of California to
product could expose
California to cause
knownbytheStateof
contains a chemical
Fiberglass insulation
cancer.
0140F01902-A
call a qualified service technician.
will not operate, don't try to repair it,
gas. Then smell for gas, including near
the floor. If you smell gas, STOP!
8. Move the gas control switch or knob
above on this label. If you don't smell
Follow "B" in the safety information
7. Wait five (5) minutes to clear out any
the control system and any gas control
the appliance and to replace any part of
a qualified service technician to inspect
has been under water. Immediately call
D. Do not use this appliance if any part
tools. If the gas control switch or knob
control switch or knob. Never use
C. Use only your hand to move the gas
which has been under water.
If you do not follow these instructions exactly,
a fire or explosion may result causing property
If you cannot reach your gas supplier,
damage, personal injury or loss of life.
Force or attempted repair may result in
10. Turn on all electric power to the
11. Set the thermostat to the desired
9. Replace control access panel.
a fire or explosion.
to "ON".
OPERATING INSTRUCTIONS
gas, go to the next step.
appliance.
callthefiredepartment.
or additional information
consult a qualified
or the gas supplier.
WARNING:
and maintained in
manufacturer's
installed, operated
accordance with the
of local codes, follow
codes. In the absence
with the manufacturers
instructions and local
This furnace must be
installedinaccordance
Code, ANSI Z223.1.
theNationalFuelGas
installer, service agency
If not
WARNING:
cause injury or
Refer to the user's
information manual
provided with this
property damage.
maintenance can
furnace. For assistance
alteration, service or
installation, adjustment,
Improper