GPH16M Submittal
Table Of Contents
26 www.goodmanmfg.com SS-GPH16M
SS-GPH16M www.goodmanmfg.com 27
•
•
• The distance between the crane hook and the top of the unit must not
be less than 60”.
• Two spreader bars must span over the unit to prevent damage to the
so that cables do not come in contact with the unit during transport.
unit on roof curb. These struts are intended to protect unit base frame
retainers and pull the struts through the base of the unit. Refer to
rigging label on the unit.
the center of gravity will cause the condenser end to be lower than the
supply air end.
To assist in determining rigging requirements, unit weights are shown on the following page.
Full perimeter roof curbs are available from the factory and are shipped unassembled. The installing contractor is responsible
the sheet metal curb is included in the curb accessory package.
•
•
curbs are not available from the factory.
•
• Support curbs on parallel sides with roof members. To prevent damage to the unit, the roof members cannot penetrate
supply and return duct openings.
unit placement is not recommended.
3-D View
14 x 20
Supply Opening
31⅝ x 14
Return Opening
70¾
40¼
14
1
5
/
6
¾
14
Insulated
Panels
R/A
S/A
20
14.625
40.25
70.75
37
67.5
1.625
3
3
14
14
31.625
20
32.875
3
16.000
O 1.750
15.250
TYP.
O.D.
I.D. O.D.
I.D.
Top View
Roof Curb Installation — Rigging