Installation Manual
6
optional and the furnace can be vented as a:
in which combustion air is taken from the installation
area or from air ducted from the outside or,
in which all combustion air supplied directly to the
furnace burners through a special air intake system
outlined in these instructions.
T
O
PREVENT
PROPERTY
DAMAGE
,
PERSONAL
INJURY
OR
DEATH
DUE
TO
FIRE
,
DO
NOT
INSTALL
THIS
FURNACE
IN
A
MOBILE
HOME
,
TRAILER
,
OR
RECREATIONAL
VEHICLE
.
WARNING
if all of the following conditions are met:
• The vent system is permanently installed per these
installation instructions.
• A room thermostat is used to control the furnace.
CANNOT be used and can cause long term
equipment damage. Bimetal thermostats, or any
during construction.
• Return air ducts are provided and sealed to the
furnace.
the system and inspected daily and replaced as
needed during construction and upon completion
of construction.
• The input rate and temperature rise are set per
the furnace rating plate.
• The furnace must be installed as a two pipe system,
using 100% outside air for combustion during
construction.
• The furnace heat exchanger, components, duct
system, air filters and evaporator coils are
the furnace is operating in any mode.
these requirements are not covered under the
warranty.
The Commonwealth of Massachusetts requires that
the following additional requirements must also be met:
• Gas furnaces must be installed by a licensed plumber
• A T-handle gas cock must be used.
• If the unit is to be installed in an attic, the passageway
to and the service area around the unit must have
In their absence, follow the latest edition of
or CAN/CSA B149.1-15 Installation Codes, local plumbing or
waste water codes, and other applicable codes.
can be obtained from any of the following:
1 Batterymarch Park
Independence, OH 441311
The rated heating capacity of the furnace should be greater than
or equal to the total heat loss of the area to be heated. The
total heat loss should be calculated by an approved method or
-
tions” published by the Air Conditioning Contractors of America.
A copy of the CAN/CSA B149.1-15 Installation Codes can
also be obtained from:
178 Rexdale Boulevard
in the Combustion and Ventilation Air Requirements section
when selecting a furnace location.
T
O
PREVENT
POSSIBLE
EQUIPMENT
DAMAGE
,
PROPERTY
DAMAGE
,
PERSONAL
INJURY
OR
DEATH
,
THE
FOLLOWING
BULLET
POINTS
MUST
BE
OBSERVED
WHEN
INSTALLING
THIS
UNIT
.
WARNING
P
OSSIBLE
PROPERTY
DAMAGE
,
PERSONAL
INJURY
OR
DEATH
DUE
TO
FIRE
,
EXPLOSION
,
SMOKE
,
SOOT
,
CONDENSATION
,
ELECTRICAL
SHOCK
OR
CARBON
MONOXIDE
MAY
RESULT
FROM
IMPROPER
INSTALLATION
,
REPAIR
OPERATION
,
OR
MAINTENANCE
OF
THIS
PRODUCT
.
WARNING
• Centrally locate the furnace with respect to the
proposed or existing air distribution system.
• Ensure the temperature of the return air entering the
is heating.
• Provide provisions for venting combustion products
outdoors through a proper venting system. Special
and combustion air intake pipe when applicable.
Refer to Vent/Flue Pipe and Combustion Air Pipe
-Termination Locations for appropriate termination