Instructions / Assembly

26
REPLACE OR CLEAN FILTER
IMPORTANT NOTE: Never operate unit without a filter installed as dust and lint will build up on internal parts resulting in
loss of efficiency, equipment damage and possible fire.
An indoor air filter must be used with your comfort system. A properly maintained filter will keep the indoor coil of your
comfort system clean. A dirty coil could cause poor operation and/or severe equipment damage.
Your air filter or filters could be located in your furnace, in a blower unit, or in “filter grilles” in your ceiling or walls. The
installer of your air conditioner or heat pump can tell you where your filter(s) are, and how to clean or replace them.
Check your filter(s) at least once a month. When they are dirty, replace or clean as required. Disposable type filters
should be replaced. Reusable type filters may be cleaned.
You may want to ask your dealer about high efficiency filters. High efficiency filters are available in both electronic and
non-electronic types. These filters can do a better job of catching small airborne particles.
MOTORS
Indoor and outdoor fan motors are permanently lubricated
and do not require additional oiling.
ALUMINUM INDOOR COIL CLEANING
(QUALIFIED SERVICER ONLY)
This unit is equipped with an aluminum tube evaporator
coil. The safest way to clean the evaporator coil is to sim-
ply flush the coil with water. This cleaning practice remains as the recommended cleaning method for both copper tube
and aluminum tube residential evaporator coils.
It has been determined that many coil cleaners and drain pan tablets contain corrosive chemicals that can be harmful to
aluminum tube and fin evaporator coils. Even a one-time application of these corrosive chemicals can cause premature
aluminum evaporator coil failure. Any cleaners that contain corrosive chemicals including, but not limited to, chlorine
and hydroxides, should not be used.
An alternate cleaning method is to use one of the products listed in TP-109* to clean the coils. The cleaners listed are the
only agents deemed safe and approved for use to clean round tube aluminum coils. TP-109 is also available on the web
site in Partner Link > Service Toolkit.
NOTE: Ensure coils are rinsed well after use of any chemical cleaners.
AIR HANDLER
AIR HANDLER HOMEOWNER’S ROUTINE MAINTENANCE RECOMMENDATIONS
BEFORE YOU CALL YOUR SERVICER
• Check the thermostat to confirm that it is properly
set.
• Wait 15 minutes. Some devices in the outdoor unit or
in programmable thermostats will prevent compres-
sor operation for awhile, and then reset automati-
cally. Also, some power companies will install de-
vices which shut off air conditioners for several min-
utes on hot days. If you wait several minutes, the
unit may begin operation on its own.
• Check the electrical panel for tripped circuit breakers or failed fuses. Reset the circuit breakers or replace fuses
as necessary.
• Check the disconnect switch near the indoor furnace or blower to confirm that it is closed.
• Check for obstructions on the outdoor unit . Confirm that it has not been covered on the sides or the top. Remove
any obstruction that can be safely removed. If the unit is covered with dirt or debris, call a qualified servicer to
clean it.
• Check for blockage of the indoor air inlets and outlets. Confirm that they are open and have not been blocked by
objects (rugs, curtains or furniture).
• Check the filter. If it is dirty, clean or replace it.
• Listen for any unusual noise(s), other than normal operating noise, that might be coming from the outdoor unit. If
you hear unusual noise(s) coming from the unit, call a qualified servicer.