Service Instructions

SERVICING
100
S-16G EEM BLOWER REPLACEMENT
For AWUF19-25, AWUF31-32, and AWUF37 Air Handlers.
1. Disconnect power at main electrical panel.
2. Remove front access panel.
3. Remove the two screws on each side holding the lower control
box and move out of the way to give access to the blower
assembly
5. Loosen or remove set screw on blower wheel hub and ensure
the wheel slides freely on the shaft of the motor.
6. Install cardboard or rug over coil to protect fins from dam-
age.
7. Remove the three 3/8" screws holding the blower in place.
8. Lower blower onto coil.
9. Slide blower assembly all the way to the left side of cabinet.