Manualshelf

HKR Installation Manual

ManualsBrandsGoodman Manualsair handlers electric furnaces5 Kilowatt Heater Coil (16,200 BTUs of Heat)
12345678910
8
Figure 14
Figure 15
8. Single Phase HKR Kits only
Mount the breaker (or terminal block) to the rear
mounting plate using the four (4) blunt tip screws
included in the unit literature bag. The screw heads
should all be located on the outside of the mounting
plate as shown in Figure 16.
Figure 16
9. Locate the 9-pin harness in the unit and remove the
male plug (Figures 17 and 18).
Figure 17
Figure 18
10. Connect the 9-pin plug from the unit to the 9-pin
plug in the heater kit.
11. Feed the 9-pin harness wires through the rubber
grommet, and feed the HKR wires through the plastic
bushing in the rear mounting plate. See Figure 19.
Ensure 6 gauge wires are going through heater kit
cover holes. Tuck excess into side of unit and route
wires over top of horshoe plate.