HKS Installation Manual

5
Figure 4
8. Remove four (4) screws attaching the horseshoe
contactor bracket and lift off of heater plate
(Figure 5).
Figure 5
9. Attach contactors to included “H” model vertical
contactor plate. Ensure contactor lugs are pointed
inward towards each other.
10. Slide the heater kit into the slot following the
direction of airflow decal for package unit operation
attached to the heater faceplate and secure with
screws provided.
11. Install two of the four mounting screws on heaterkit
(Figure 6).
Figure 6
12. Place vertical contactor bracket behind corner post.
13. Secure vertical contactor plate and heater kit to unit
using remaining two mounting screws (Figure 7).
Figure 7
NOTE: Steps 14 and 17 pertain to kits that contain
circuit breakers.
14. Attach the circuit breaker mounting bracket inside
the top left corner of the electric heat kit box
(Figure 8 and 9). Ensure the breaker is oriented with
OFF position to the left. Remove the two (2) sheet
metal screws prior to installation and re-attach as
shown in Figure 8.