HKS Installation Manual

Figure 19

12. Install rear mounting plate with the two (2) screws

removed in step 5.

13. Connect the line voltage leads to the breaker(s),

terminal block, or contactor as applicable.

14. If heat kit includes breakers, remove rectangular

knockout(s) from outside cover as required for

access.

15. Install the cover with the two (2) screws removed in

step 4, routing the line voltage wires through the

rubber grommet as shown in Figure 20.

Figure 20

16. Install control box door and blower door.

17. Reconnect power and test.

NOTE: In Package Units:

HKP-05C replaces HKR-05C

HKP-10C replaces HKR-10C

HKP-15C replaces HKR-15C

HKP-20C replaces HKR-20C

NOTE: If installing an HKP heater kit on a unit that only

has the corresponding HKR heater kit shown on

the serial plate, use a permanent marker to add

the HKP model to the serial plate (the data is the

same as the HKR). If the corresponding HKR model

number is not on the serial plate, the heater kit

can not be used.

NOTE: On earlier (M) models it may be necessary to

notch or cut heater kit shroud to accomodate

screws in heater (Figure 21).

Figure 21