GPD14 Installation Instructions

ManualsBrandsGoodman ManualsCentral Air ConditionersGPD14 - Outdoor Thermostat

Part Descripton Qty.

Webbed Grommet 1

Cutting Screws 2

Housing Assembly (contains parts below) 1

Door 1

Box 1

Top 1

Bottom Screen 1

Thermostat 1

Thermostat Harness 1

Screws 6

IO-771A Installation Instructions 1

Kit Components

Table 1

2. Remove the blower door in order to access the thermostat

plug on the inside of the unit. The harness is labeled “OUT-

DOOR THERMOSTAT”.

3. Remove the knockout from the duct panel located next to the

blower door (see Figure 1).

MOUNTING

DIMPLES

REMOVE KNOCKOUT

AND CUT “X” IN

INSULATION

AS SHOWN

Figure 1

ATTENTION INSTALLING PERSONNEL

As a professional installer, you have an obligation to know the

product better than the customer. This includes all safety precau-

tions and related items.

Prior to actual installation, thoroughly familiarize yourself with this

Instruction Manual. Pay special attention to all safety warnings.

Often during installation or repair, it is possible to place yourself in

a position which is more hazardous than when the unit is in op-

eration.

Remember, it is your responsibility to install the product safely

and to know it well enough to be able to instruct a customer in its

safe use.

Safety is a matter of common sense...a matter of thinking before

acting. Most dealers have a list of specific good safety

practices...follow them.

The precautions listed in this Installation Manual are intended as

supplemental to existing practices. However, if there is a direct

conflict between existing practices and the content of this manual,

the precautions listed here take precedence.

WARNING

HIGH VOLTAGE!

DISCONNECT ALL POWER BEFORE SERVICING OR INSTALLING

THIS UNIT.

MULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE

TO DO SO MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR

DEATH.

CAUTION

O AVOID POSSIBLE PERSONAL INJURY, USE EXTREME CAUTION IF USING

POWER TOOLS TO REMOVE THE SMALL BREAKER MOUNTING BRACKETS.

THE

BRACKETS MAY QUICKLY ROTATE AND CAUSE INJURY.

INSTRUCTIONS

1. Remove all parts from the OTDFPKG-01 kit. Compare parts

to Table 1 to insure all needed parts are present before pro-

ceeding.

OTDFPKG-01 OUTDOOR THERMOSTAT

FOR DUAL FUEL PACKAGE

INSTALLATION INSTRUCTIONS

IO-771A

9/2013

Summary of content (2 pages)

PAGE 1
OTDFPKG-01 OUTDOOR THERMOSTAT FOR DUAL FUEL PACKAGE INSTALLATION INSTRUCTIONS ATTENTION INSTALLING PERSONNEL Kit Components As a professional installer, you have an obligation to know the product better than the customer. This includes all safety precautions and related items. Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual. Pay special attention to all safety warnings.
PAGE 2
4. There will be insulation behind the knockout on the inside of the unit. Cut an “X” into the insulation as shown in Figure 1. 5. Snap in the webbed grommet into the resulting hole in the duct panel. 6. Remove the door from the housing assembly. Place the plug of the thermostat through the grommet and through the hole cut into the insulation into the inside of the unit. 7. With the cutting screws shipped with the kit, mount the housing to the duct panel using the locating dimples on the panels.