Use and Care Manual

SPECIFICATIONS
THIS INFLATOR OPERATES ONLY ON DC 12 VOLT. DO NOT ATTEMPT TO OPERATE
THIS INFLATOR WITH ANY OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR RECONFIGURE
INFLATOR FROM ITS ORIGINAL DESIGN OR PERSONAL INJURY OR BODILY HARM MAY OCCUR.
Voltage DC 12 Volt
Power Requirement DC 12 Volt – For use with 12 Volt DC Power Outlet Only
Note: This unit is equipped with fuse protection. If at some point your inflator fails to operate,
check the fuse in the end of the 12 Volt plug. Please refer to the correct fuse size that is stated on the
side of the 12 Volt plug. To replace the fuse, simply unscrew the 12 Volt power plug tip, remove
existing fuse, install new fuse and reassemble power plug tip.
TROUBLESHOOTING

2
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Unit will not
start.
1. Cord not plugged in.
2. Fuse in 12 Volt DC
power cord blown.
1. Plug into a working 12 Volt DC Power Outlet.
2. Replace fuse in 12 Volt DC power cord. (Please
see image below).