System Description

TEL : [phone]
Page
28 of 173
FAX : [phone]
Issued Date
:
Feb. 14, 2020
Form version: 181113
FCC SAR TEST REPORT
Report No. : FA9O2119
7.4 Zoom Scan
Zoom scans are used assess the peak spatial SAR values within a cubic averaging volume containing 1 gram and 10
gram of simulated tissue. The zoom scan measures points (refer to table below) within a cube shoes base faces are
centered on the maxima found in a preceding area scan job within the same procedure. When the measurement is done,
the zoom scan evaluates the averaged SAR for 1 gram and 10 gram and displays these values next to the job’s label.
Zoom scan parameters extracted from FCC KDB 865664 D01v01r04 SAR measurement 100 MHz to 6 GHz.
7.5 Volume Scan Procedures
The volume scan is used for assess overlapping SAR distributions for antennas transmitting in different frequency bands.
It is equivalent to an oversized zoom scan used in standalone measurements. The measurement volume will be used to
enclose all the simultaneous transmitting antennas. For antennas transmitting simultaneously in different frequency bands,
the volume scan is measured separately in each frequency band. In order to sum correctly to compute the 1g aggregate
SAR, the EUT remain in the same test position for all measurements and all volume scan use the same spatial resolution
and grid spacing. When all volume scan were completed, the software, SEMCAD postprocessor can combine and
subsequently superpose these measurement data to calculating the multiband SAR.
7.6 Power Drift Monitoring
All SAR testing is under the EUT install full charged battery and transmit maximum output power. In DASY measurement
software, the power reference measurement and power drift measurement procedures are used for monitoring the power
drift of EUT during SAR test. Both these procedures measure the field at a specified reference position before and after
the SAR testing. The software will calculate the field difference in dB. If the power drifts more than 5%, the SAR will be
retested.