System Description

TEL : [phone]
Page
43 of 173
FAX : [phone]
Issued Date
:
Feb. 14, 2020
Form version: 181113
FCC SAR TEST REPORT
Report No. : FA9O2119
DC-HSDPA 3GPP release 8 Setup Configuration:
a. The EUT was connected to Base Station Agilent E5515C referred to the Setup Configuration below
b. The RF path losses were compensated into the measurements.
c. A call was established between EUT and Base Station with following setting:
i. Set RMC 12.2Kbps + HSDPA mode.
ii. Set Cell Power = -25 dBm
iii. Set HS-DSCH Configuration Type to FRC (H-set 12, QPSK)
iv. Select HSDPA Uplink Parameters
v. Set Gain Factors (β
c
and β
d
) and parameters were set according to each Specific sub-test in the following table,
C10.1.4, quoted from the TS 34.121
a). Subtest 1: β
c
/β
d
=2/15
b). Subtest 2: β
c
/β
d
=12/15
c). Subtest 3: β
c
/β
d
=15/8
d). Subtest 4: β
c
/β
d
=15/4
vi. Set Delta ACK, Delta NACK and Delta CQI = 8
vii. Set Ack-Nack Repetition Factor to 3
viii. Set CQI Feedback Cycle (k) to 4 ms
ix. Set CQI Repetition Factor to 2
x. Power Ctrl Mode = All Up bits
d. The transmitted maximum output power was recorded.
The following tests were conducted according to the test requirements outlines in 3GPP TS 34.121 specification.
A summary of these settings are illustrated below:
Setup Configuration