User's Manual

User Manual Draft

- Earbuds

- Charging case

-Charging Cable

Setup Instruction:

1. Open the earbuds case and keep the earbuds inside.

2. Press and hold the paring button until the light starts pulsing.

3. Go to Bluetooth settings on your device and make sure the Bluetooth is on.

4. Tape “Earbuds” and connect.

EMC Compliance

Important: This product has demonstrated EMC compliance under conditions that included the

use of compliant peripheral devices and shielded cables between system components. It is

important that you use compliant peripheral devices and shielded cables between system

components to reduce the possibility of causing interference to radios, televisions, and other

electronic devices.

United States Federal Communications Commission (FCC)

Regulatory Compliance

FCC ID:

Left earbud: A4RG1007

Right earbud: A4RG1008

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

PAGE 1
User Manual Draft - Earbuds - Charging case -Charging Cable Setup Instruction: 1. 2. 3. 4. Open the earbuds case and keep the earbuds inside. Press and hold the paring button until the light starts pulsing. Go to Bluetooth settings on your device and make sure the Bluetooth is on. Tape “Earbuds” and connect. EMC Compliance Important: This product has demonstrated EMC compliance under conditions that included the use of compliant peripheral devices and shielded cables between system components.
PAGE 2
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ● ● ● ● Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.