User Manual

Regulatory information

Regulatory information, certification, and compliance marks can be found on your device.

Additional regulatory and environmental information can be found at XXXXXXXX<website>.

Manufacturer address: Google LLC, 1600 Amphitheatre Parkway, Mountain View, CA 94043.

RADIO FREQUENCY EXPOSURE

For the device, maintain a distance of 20 cm (8 inches) from your body to be consistent with

how the device is tested for compliance with RF exposure requirements.

FCC & ISED CANADA REGULATORY COMPLIANCE

FCC Regulatory Compliance

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

● Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Google could void your authority to

operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause

undesired operation.

EMC Compliance Statement

Important: This device [and its power adapter] have demonstrated Electromagnetic

Compatibility (EMC) compliance under conditions that included the use of compliant peripheral

devices and shielded cables between system components. It is important that you use

compliant peripheral devices and shielded cables between system components to reduce the

possibility of causing interference to radios, televisions, and other electronic devices.

Radio Frequency Exposure

This device meets the U.S. Federal Communications Commission's (FCC) requirements for

exposure to radio waves and is designed and manufactured not to exceed the FCC's emission

limits for exposure to radio frequency (RF) energy. To comply with FCC RF exposure

PAGE 1
Regulatory information Regulatory information, certification, and compliance marks can be found on your device. Additional regulatory and environmental information can be found at XXXXXXXX. Manufacturer address: Google LLC, 1600 Amphitheatre Parkway, Mountain View, CA 94043. RADIO FREQUENCY EXPOSURE For the device, maintain a distance of 20 cm (8 inches) from your body to be consistent with how the device is tested for compliance with RF exposure requirements.
PAGE 2
compliance requirements, a distance of at least 20 cm should be maintained between the antenna of this device and persons during device operation. This device must not be co-located or operating in conjunction with any other antenna or transmitter. U.S. contact information: Google LLC, 1600 Amphitheatre Parkway, Mountain View, CA 94043 Contact: g.
PAGE 3
When using the device next to your body, maintain a distance of 20 cm (8 inches) from your body to be consistent with how the device is tested for compliance with RF exposure requirements.