SDS

ManualsBrandsGoogle ManualsHeatingNest Learning Thermostat (4th Gen) with Nest Temperature Sensor (2nd Gen) 2-Pack - Polished Obsidian

福建飞毛腿动力科技有限公司

Ver.

V1.4

File name

H043 (1S1P) RECYCLED COBALT Battery

Specification

Security

Level

Internal

public

Page

1/25

Battery Specification

Product Name：

Rechargeable Li-ion Polymer Battery

Product Model：

G5%;

Product Number：

RH5G14010017/RH5G14010018

Prepared by : Date:

Standard by : Date:

Checked by : Date:

Approved by : Date:

Project

Manager

Customer

Approval

Summary of content (24 pages)

PAGE 1
福建飞毛腿动力科技有限公司 File name H043 (1S1P) RECYCLED COBALT Battery Specification Security Level Internal public Ver. V1.
PAGE 2
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 修订记录/Revision history Version Prepared by Date Check by V1.0 Yawang Jie 2021/07/21 Qinglang Wu Remark Original release 1. Update cell information 2. Update pack Typical capacity V1.1 Yawang Jie 2021/09/01 Qinglang Wu 3. Update pre-charge current 4. Update ship voltage 5. Update mechanical drawing 1. Update label. 2. Modify project name. V1.
PAGE 3
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Contents /内容 1. Scope/范围 ............................................................................4 2. Standard compliance/参考标准 ............................................................ 4 3. Product name and model/产品型号名称 .....................................................4 3.1 Product Name/产品名称: Rechargeable Li-ion Polymer Battery .......................................
PAGE 4
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 1. Scope/范围 The specification describes the requirements for GR3BX Rechargeable Li-ion Polymer battery pack. Battery supplied by Fujian SCUD Power Technology Co., Ltd. 本规格书适用于 GR3BX 锂离子电池，由福建飞毛腿动力科技有限公司生产。 2. Standard compliance/参考标准 The battery should be complied with the standard of GB 31241-2014.
PAGE 5
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Lithium-ion Polymer ATL Rechargeable cell 3.7V 354647B 855 (Nominal) 835 (Rated） ≤ 65mΩ 4.2 Battery Characteristics No. Item Specification 4.2.1 Rated Capacity /额定容量 820mAh 4.2.2 Nominal Capacity /标称容量 840mAh 4.2.3 Nominal voltage /标称电压 3.7V 4.2.4 Charge method /充电模式 CC/CV 4.2.5 Charger limit voltage /充电限制电压 4.2V 4.2.6 4.2.7 4.2.8 4.2.9 4.2.10 4.2.11 4.
PAGE 6
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 5. Performance/性能 5.
PAGE 7
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 High Temperature After standard charged, battery should be stored in a Discharge time discharge temperature-controlled environment at 55±2℃ for ≥300 mins /高温放电 2 hours. after storage, battery should be discharged / 放电时间≥300 分钟。 with 0.2C to 3.0V cut-off. /电池按规定充电结束后，将电池放入 55℃±2℃的高温箱中恒温 2h，然后以 0.2C 电流放电至 3.0V.
PAGE 8
Cycle Life/循环寿命 Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 A) 1000 cycles charging/discharging is repeated in A) The battery capacity should the below condition: be more than 80% of Initial Environment: 12±2℃/25±3℃/45℃±2℃ capacity at every 100 cycles, Charging: 0.5C CC to 4.2V then CV to 0.05C. total 1000 cycles. Discharging: 0.5C Discharge end of voltage: 3.
PAGE 9
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 5.2 Environmental Safety Test/环境安全试验 Items Conditions and others Performances Low Pressure The standard charged battery is to be stored in the The battery should be no leakage, no 低气压 vacuum chamber. After close the vacuum chamber, venting, no rupture, no fire or no then reduce the pressure, until the internal pressure is explosion. no more than 11.
PAGE 10
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 increased until a peak acceleration of 8 gn occurs (approximately 50 Hz). A peak acceleration of 8 gn is then maintained until the frequency is increased to 200 Hz. /电池按规定充电结束后，将电池固定在振动台上，不可使电池变形。采用正弦波进行振动，并以对数扫频方式在 15mins 内从 7Hz 扫频到 200Hz 并返回到 7Hz。振动沿样品互相垂直的三个方向（其中一个方向必须与样品正负极所在平面垂直）进行，每个方向按上述对数扫频方式重复 12 次，振动 3h。对数扫频方式如下：7Hz～18Hz 保持 9.8m/s2 的峰值加速度。将振幅保持在 0.8mm（位移为 1.
PAGE 11
Drop Test Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 The battery is to be dropped down to concrete(or steel OCV≥90% initial OCV（open /跌落试验（软包电 plate) from a height of 1m for 6 times circuit voltage）池须与整机配合测 (with direction X,Y,Z each 1 times). The battery should be no leakage, no 试） Discharge with 0.5 C to 3.0V cut-off within 1 fire or no explosion. The test need device hour after fully-charged. to support.
PAGE 12
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 The standard charged battery should be stored in the oven with requirements of 90%-95% relative humidity at 40±2℃ for 48 hours, after High Humidity& High Temperature /恒定湿热 Discharge time finishing, inspect appearance and measure the recovery capacity by standard charge/discharge cycling after discharging with 0.2C to 3.0V cut-off at 23℃±2℃.
PAGE 13
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 1st Short circuit protection current /一段短路保护值 A 7.68 16.25 32.71 1st Short circuit protection current delay time /一段短路保护延迟时间 us 188 300 450 Permission 0V charging/0V 充电 V - - 1.2 By connecting the charger more than Minimum operating voltage for 0V charging (Vst). Secondary Protection 2nd Over charge detection voltage /一段过充电保护电压 V 4.25 4.275 4.
PAGE 14
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Other Current consumption /工作消耗电流 μA - 5 8 Standby Current μA - - 0.2 mΩ - - 88 /休眠电流 Internal Resistance of PCM /保护板内阻 5.3.2 Circuit Diagram/电路原理图 5.3.
PAGE 15
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Bottom Layer(mirrored): Top Overlay&Solder: Bottom Overlay/Solder(mirrored): Drill Guide: 5.3.4 BOM/物料清单 No. Type Description 1 Capacitor 0402-16V-0.
PAGE 16
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 DATONG 8 NI-PAD 7.0*3.1*0.1 B+/B- 2 9 PCB H043-1S1P-DP-A02 / 1 10 Connector J1 1 11 UV glue 326-loctit-1 升/桶 / 0.01ml LOCTITE / 12 Under fill glue HS-601UF-B-底部 / 0.04ml HANSTAR / 50270-003H0H1-L18.3mm-AWG28 #-UL3302-ACES /FUCI(ALT.) Victory Giant /Redboard(ALT.) ACES 7.0*3.1*0.1 / / 5.
PAGE 17
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Over Load The standard charged battery is to be discharged The battery should be no fire, no Protection with 1.5 times discharge protection current, until explosion or no leakage. /超载 the protection circuit starts. 电池组应不起火，不爆炸，不漏液。将电池按标准充电方式充满电后，然后以 1.5 倍过流保护电流恒流放电至保护电路起动。 External Short The test should be conducted under 25±5℃.
PAGE 18
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Heating test A battery is to be heated in a circulating air oven. The battery should be no fire, no explosion. The temperature of the oven is to be raised at a /电池应不起火、不爆炸。 rate of （5℃±2℃）/min to a temperature of /热滥用 130 °C . The oven is to remain for 30 minutes. /电池放置于热箱中，温度以（5℃±2℃）/min 的速率升至 130℃±2℃并保温 30mins。 6. Reliability Performance/可靠性能 6.
PAGE 19
4 Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Mark and Label/标签 Refer to the attachment of battery label.
PAGE 20
7.2 Mechanical diagrams/机械图表 Refer to the attachment of battery structure diagram.
PAGE 21
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 Refer to the attachment of PCM board.
PAGE 22
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 8.
PAGE 23
9. Others/其他 9.1 Odor/气味 The battery do not product special smell or harmful odor./本电池不会产生特别或有害的气味 9.2 Protection for Environment/环境保护 The material used for packing should meet the criterion to protect environment./封装电池所用材料须全部符合环境保护标准 10.Warning and notice 1、 Do not put the battery into a fire, or heat the battery. 2、 Do not store the battery in high temperature environment. 3、 Do not connect the battery reversed in positive (+) and negative (-) terminals in the charger or equipment.
PAGE 24
Rechargeable Li-Ion Polymer Battery Security level Internal public H043(1S1P) RECYCLED COBALT Battery Specification Ver. V1.4 with (battery manufacturer’s name or end product manufacturer’s name and part number) only. Use of another battery may present a risk of fire or explosion. 3、For long-term storage, please charge at 0.5C for about one hour in advance.