SDS

Rechargeable Li-Ion Polymer Battery
Security level
Internal public
H043(1S1P) RECYCLED COBALT Battery Specification
Ver.
V1.4
飞毛腿公司机密，未经许可不得扩散。 第 10页, 共 25页
increased until a peak acceleration of 8 gn occurs
(approximately 50 Hz). A peak acceleration of 8 gn is
then
maintained until the frequency is increased to 200 Hz.
/电池按规定充电结束后，将电池固定在振动台上，
不可使电池变形。采用正弦波进行振动，并以对数
扫频方式在 15mins 内从 7Hz 扫频到 200Hz 并返回
到 7Hz。振动沿样品互相垂直的三个方向（其中一
个方向必须与样品正负极所在平面垂直）进行，每
个方向按上述对数扫频方式重复 12 次，振动 3h。
对数扫频方式如下：7Hz～18Hz 保持 9.8m/s2 的峰
值加速度。将振幅保持在 0.8mm（位移为 1.6mm）
直至峰值加速度达到 78.4m/s2（频率约为 50Hz）。
保持 78.4m/s2 的峰值加速度直到频率增长到
200Hz。
Acceleration Test
/加速度冲击
电池按照 Spec 规定充电后，固定在冲击台上，最初
3ms 内，最小平均加速度为 75g.N,峰值加速度为
150+/-25g.N,持续脉冲时间为 6+/-1ms,电池每个方
向进行三次加速度冲击。测试后，电池按标准充电
方式进行一次放电充电循环。
A standard charged battery is to be firmly secured to
the platform of acceleration test equipment.
Each shock is to be applied in a direction normal to
the face of the battery. For each shock the cell is to be
accelerated in such a manner that during the initial 3
milliseconds the minimum average acceleration is
75g.N. The peak acceleration should be between 125
and 175g. N.
The acceleration shock test last for 6+/-1ms.
After testing, charge and discharge the battery with
standard method.
The battery should be no fire, no
explosion, or no leakage.
电池应不起火，不爆炸，不漏液。