SDS

Rechargeable Li-Ion Polymer Battery
Security level
Internal public
H043(1S1P) RECYCLED COBALT Battery Specification
Ver.
V1.4
飞毛腿公司机密，未经许可不得扩散。 第 11页, 共 25页
Drop Test
/跌落试验（软包电
池须与整机配合测
试）
The test need device
to support.
The battery is to be dropped down to concrete(or steel
plate) from a height of 1m for 6 times
(with direction X,Y,Z each 1 times).
Discharge with 0.5 C to 3.0V cut-off within 1
hour after fully-charged.
/电池按规定充电结束后，将电池样品由高度为 1m
的位置自由跌落到水泥地板或钢板上，从 X、Y、Z
正负方向（六个方向）每个方向自由跌落 1 次。自
由跌落结束后，将电池以 0.5C 电流放电至 3.0V。
然后进行充放电循环
OCV≥90% initial OCV（open
circuit voltage）
The battery should be no leakage, no
fire or no explosion.
开路电压不低于初始电压 90%,并
能进行正常的充放电。电池应不泄
露、不起火和不爆炸。
High temperature
stress relieving
/高温应力消除
（注塑成型的热塑
性外壳电池适用）
Applicable for the
thermoplastic shell
battery for injection
molding.
The standard discharged battery is to be placed in a
70+/-2℃ circulating air oven for 7 hours. After
finishing the test, remove it and restore to room
temperature.
将电池按照 4.5.1 规定的试验方法充满电后，在
70+/-2℃的鼓风恒温箱中搁置 7Ｈ，取出并恢复至室
温。
The enclosure does not result in the
physical deformation that causes the
internal components to be exposed.
外壳不能发生导致内部组成暴露
的物理变形。
Using at high
temperature
/高温使用
The standard charged battery is to be placed in the
high temperature experiment box, emperature is set
as the battery charging upper-limit temperature, or
battery discharging upper- limit temperature, or cell
charge upper-limit temperature, or cell discharge
upper-limit temperature, which specified in the
specification, or 80 ℃,choose the highest one, and
keep for 7 hours after waiting for the sample surface
temperature stability.
将满电样品置于高温实验箱内，将高温箱温度设为
SPEC 规定的电池组充电上限温度，电池组放电上
限温度，电芯充电上限温度，电芯放电上限温度，
以及 80℃中的最大值，待样品表面温度稳定后保持
7H。
The battery should meet one of the
requirement:
1)Not discharge, store in the high
temperature experiment box , there
should be no fire, no explosion, or
no leakage.
2)Connect with charge/discharge
device,
conducted with a standard
discharge/charge cycle.
样品应满足下列条件之一：
1)切断放电电路，电池应不起火，
不爆炸，不漏液
2)未切断电路，在高温中按规格书
进行一次标准放电充电循环。