SDS

Rechargeable Li-Ion Polymer Battery
Security level
Internal public
H043(1S1P) RECYCLED COBALT Battery Specification
Ver.
V1.4
飞毛腿公司机密，未经许可不得扩散。 第 17页, 共 25页
Over Load
Protection
/超载
The standard charged battery is to be discharged
with 1.5 times discharge protection current, until
the protection circuit starts.
将电池按标准充电方式充满电后，然后以 1.5
倍过流保护电流恒流放电至保护电路起动。
The battery should be no fire, no
explosion or no leakage.
电池组应不起火，不爆炸，不漏液。
External Short
Circuit
/外部短路
The test should be conducted under 25±5℃.
The standard charged battery is to be
short-circuited by connecting the positive and
negative terminals of the battery with copper
wire having a resistance about 80mΩ±20 mΩ.
until the protection circuit starts.
将电池按照标准充电方式充满电后，短路电池
组的正负极端子，外部短路总电阻为 80+/-20m
Ω,直至保护电路起动。
The battery should be no fire, no
explosion, no smoke or no leakage.
电池应不起火，不爆炸，不冒烟或漏
液。
Reverse Charge
/反向充电
The standard charged battery should be reverse
charged with recommending current for 90
minutes.
将电池按标准充电方式充满电后，然后以推荐
充电电流反向充电 90min。
The battery should be no fire, no
explosion, no smoke or no leakage.
电池应不起火，不爆炸，不冒烟或漏
液。
ESD
/静电
The standard charged battery should be test under
ESD ±8kV contact discharge and ±15kV air
discharge for each 5 times. The interval of
discharge is 1min.
对充饱电后的电池（金属端子）进行±8kV 接
触放电与±15kV 空气放电各 5 次，每次放电间
隔 1 分钟。
The function of battery should be work
well.
电池所有功能正常。
Drop Impact test
/重物冲击测试
（对于软包装电
池，本条不适用
/This item is not
applicabel for
polymer battery）
Battery is to be placed on a flat surface.
To place 15.8mm±0.2mm diameter bar across
the center of standard charged battery, and drop
9.1kg weight from 610±25mm height onto the
battery. Then keep for 6hr,
/充饱电的电池放置于平面冲击台上，并将一个
直径 15.8mm 的钢柱放置于电池中心，钢柱的
纵轴平行于平面，让品质 9.1kg 的重物从
610mm±25mm 高度自由落到电池中心上方的
钢柱上，测试完毕，观察 6 小时。
The battery should be no fire, no
explosion.
/电池应不起火、不爆炸。