SDS

Rechargeable Li-Ion Polymer Battery
Security level
Internal public
H043(1S1P) RECYCLED COBALT Battery Specification
Ver.
V1.4
飞毛腿公司机密，未经许可不得扩散。 第 8页, 共 25页
Cycle Life/循环寿命
A) 1000 cycles charging/discharging is repeated in
the below condition:
Environment: 12±2℃/25±3℃/45℃±2℃
Charging: 0.5C CC to 4.2V then CV to 0.05C.
Discharging: 0.5C
Discharge end of voltage: 3.0V
Cell is to be rested for 5 minutes after charged and
5 minutes after discharge.
Measure each of one hundred cycle capacity with
standard charge and discharge, and record it.
B) 1000 cycles charging/discharging is repeated in
the below condition:
Environment: 12±2℃/25±3℃/45℃±2℃
Charging: 0.5C CC to 3.95V then CV to 0.05C.
Discharging: 0.5C
Discharge end of voltage: 3.0V
Cell is to be rested for 5 minutes after charged and
5 minutes after discharge.
Measure each of one hundred cycle capacity with
standard charge and discharge, and record it.
A) 在环境温度 12±2℃/25±3℃/45℃±2℃的条件
下，0.5C 恒流充至 4.2V 后恒压至 0.05C，搁置
5min，然后以 0.5C 电流放电至 3.0V，放电结束后，
搁置 5min，再进行下一个充放电循环。每 100 次
按标准充放电条件测量电池的恢复容量并记录。
B) 在环境温度 12±2℃/25±3℃/45℃±2℃的条件
下，0.5C 恒流充至 3.95V 后恒压至 0.05C，搁置
5min，然后以 0.5C 电流放电至 3.0V，放电结束后，
搁置 5min，再进行下一个充放电循环。每 100 次
按标准充放电条件测量电池的恢复容量并记录。
A) The battery capacity should
be more than 80% of Initial
capacity at every 100 cycles,
total 1000 cycles.
B) The battery capacity should
be more than 85% of Initial
capacity at every 100 cycles,
total 1000 cycles.
A) 每循环 100 次后电池容量
为初始容量 80%以上，循环
1000 次。
B) 每循环 100 次后电池容量
为初始容量 85%以上，循环
1000 次。