Installation Instructions

This module is intended for OEM integrators only. Per FCC KDB 996369 D03

OEM Manual v01 guidance, the following conditions must be strictly followed

when using this certified module:

KDB 996369 D03 OEM Manual v01 rule sections:

2.2 List of applicable FCC rules

This module has been tested for compliance to FCC Part 15,

2.3 Summarize the specific operational use conditions

The module is tested for standalone mobile RF exposure use condition. Any

other usage conditions such as co-location with other transmitter(s) or being

used in a portable condition will need a separate reassessment through a

class II permissive change application or new certification.

2.4 Limited module procedures

Not applicable.

2.5 Trace antenna designs

Not applicable.

2.6 RF exposure considerations

This equipment complies with FCC mobile radiation exposure limits set

forth for an uncontrolled environment. This equipment should be installed

and operated with a minimum distance of 20cm between the radiator &

your body. If the module is installed in a portable host, a separate SAR

evaluation is required to confirm compliance with relevant FCC portable

RF exposure rules.

2.7 Antennas

The following antennas have been certified for use with this module; antennas of the

same type with equal or lower gain may also be used with this module. The antenna

must be installed such that 20 cm can be maintained between the antenna and users.

Brand

TDK

Model

ANT162442DT-2001A2

Max Gain

2.4GHz: 2.1 dBi

NII-1,NII-2A: 1 dBi

NII-2C: 1.5 dBi

NII-3: 2.3 dBi

Antenna Type

Chip

Antenna connector

N/A

PAGE 1
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the following conditions must be strictly followed when using this certified module: KDB 996369 D03 OEM Manual v01 rule sections: 2.2 List of applicable FCC rules This module has been tested for compliance to FCC Part 15, 2.3 Summarize the specific operational use conditions The module is tested for standalone mobile RF exposure use condition.
PAGE 2
.8 Label and compliance information The final end product must be labeled in a visible area with the following: “Contains FCC ID: HFSJA1”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. 2.
PAGE 3
OEM/Host manufacturer responsibilities OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module. The final product must be reassessed against all the essential requirements of the FCC rule such as FCC Part 15 Subpart B before it can be placed on the US market. This includes reassessing the transmitter module for compliance with the Radio and EMF essential requirements of the FCC rules.