Glass Installation and Operating Instructions Submitted by: Google Inc.
Table of contents Turning the device on Setting up the device Normal operation Charging Frame removal Note on interference in a residential installation Note: At the time of submission much of the Glass user experience is still under active development. This document is submitted in a Draft state with much information still To Be Determined (TBD). A final version of this Installation and Operating guide will be resubmitted when the software is complete.
Turning the device on ● If the device has sufficient battery charge (or is connected to a power source), the device may be powered up by pressing and holding the power button for 3 seconds. Turning the device off ● From on the device may be powered down by pressing and holding the power button for 3 seconds.
Frame removal ● The pod can be removed from the Glass frame as follows: ○ Remove screw on inside of pod ○ Gently lift pod off of frame ■ Note that the FCC ID can be seen on inside of the frame ○ Reattach pod to new frame with screw.
Note on interference in a residential installation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
