User Manual

76 77
/ Camera Housing
ASSEMBLING THE CAMERA HOUSING
To Remove the Camera From the Housing:
1. Li the front of the latch up to disengage it from the camera housing.
2. Pivot the latch backward and pull it up to release the backdoor.
3. Pull open the housing backdoor and remove the camera.
Slim housing surfboard mount installation
Slim housing remove camera
Slim housing insert camera
Slim housing closed Swapping housing doors
Quick Release Buckle + Thumb Screw + Slim housing = Complete Unit
/ Camera Housing
To Secure the Camera in the Housing:
1. Open the housing and drop the camera into position.
2. Make sure the seal around the backdoor is free of debris.
3. Close the housing backdoor and squeeze it closed to ensure a
good seal.
4. Pivot the hinged arm backwards and hook the lip of the latch into
the grooved top of the housing backdoor.
5. Push the latch down to snap it into place.
Slim housing surfboard mount installation
Slim housing remove camera
Slim housing insert camera
Slim housing closed Swapping housing doors
Quick Release Buckle + Thumb Screw + Slim housing = Complete Unit
WARNING: Always secure the camera in its housing when using
the camera in or around water. Do not get the camera or the
battery wet.