User's Manual

26 27
SPOT METER
Turn on Spot Meter when filming from within dark space pointing camera into
a brighter setting, such as filming the outdoors from within a car. When set to
ON,
appears in the LCD window.
OFF (default)
ON
To change Spot Meter, verify camera is in Settings menu. If is
not showing, press
repeatedly until it appears:
1. Press
to enter menu.
2. Use
to cycle through Settings mode’s menu to locate .
3. Press
to enter Capture Settings.
4. Use
to locate .
5. Press
to enter Spot Meter sub-menu.
6. Use
to cycle through options
7. Press
to select highlighted option.
8. To exit, hold down
for two seconds.
cHanGInG settInGs: caPtUre settInGs
cHanGInG settInGs: caPtUre settInGs
VIDEO LOOPING
Not certain when the desired action will happen, but want to be sure it’s
captured on video? Set camera to Video Looping to continuously “record and
over-write” until
is pressed.
Off (default)
Max video
Camera records until memory card is full, then over-writes
with new video
5 min video
Camera records for 5 minutes, then over-writes and begins
a new video
20 min video
Camera records for 20 minutes, then over-writes and begins
a new video
60 min video
Camera records for 60 minutes, then over-writes and begins
a new video
120 min video
Camera records for 120 minutes, then over-writes and begins
a new video
Note: Multiple chapter files are written to memory card. This allows for small
segments of content to be over-written during loop recording.
HERO3_UM_silver_Edition_ENG_MASTER.indd 26-27 9/19/12 1:01 PM