Operation Manual

Step 4

Hook the Side

edge of the

Sync Cable into the primary

camera’s right side groove.

Step 5

Push both Sides

and into

the HERO Ports of each camera.

Make sure the Sync Cable is fully

inserted and lays ﬂush against

the back of the cameras.

Step 6

Close the housing.

Note: Upon insertion of the Sync Cable, the primary (right) camera will automatically set itself to UP mode (right side up), and the

secondary (le) camera will automatically set itself to UPd mode (upside down). These settings are required for simultaneous

capture, and for recording synchronized footage to create 3D content.