User's Manual

50 51
caMera asseMblY
ATTACHING YOUR CAMERA TO MOUNTS
To attach your HERO3 camera to a mount, you will need an attachment buckle,
thumb screw or other hardware depending on the mount you are using. For
more information on mounts, visit gopro.com/support.
Attachment
Buckle
Thumb Screw Waterhousing Complete Unit
USING CURVED OR FLAT ADHESIVE MOUNTS
The curved and flat adhesive mounts make it easy to attach the camera to curved and
flat surfaces of helmets, vehicles and gear. With the attachment buckle the assembled
camera housing can be clicked ON/OFF the secured adhesive mounts.
Flat Adhesive Mount Curved Adhesive Mount
caMera asseMblY
ATTACHING ADHESIVE MOUNTS
PRO
TIPS:
Apply to clean surface only. Wax, oil, dirt or other debris will
reduce adhesion, which can result in a weak bond and risk of
losing camera should connection fail.
Attach mount in room temperature conditions. Mount’s
adhesive will not bond properly if applied in cold or damp
environments to cold or damp surfaces, or if the surface is not
room temperature.
Adhesive mounts should only be mounted to smooth surfaces;
porous or textured surfaces will not enable a proper bond.
When applying mount, firmly press into place and ensure full
contact over entire surface.
For best results, attach the mount a minimum of 24 hours
prior to use.
▶See gopro.com/support for more information on mounts.
Locking Plug
Using the HERO3 in high impact sports such as surfing or skiing
where significant impact may occur? Use the special locking
plug which securely locks the attachment buckle fingers into
place--helping prevent accidental housing release from the mount.
The circular ring fits over the thumbscrew and acts as a leash to
prevent dropping or losing the locking plug.