Operation Manual

10 11
GETTING STARTED GETTING STARTED
ASSEMBLING THE ARRAY
Installing the Cameras
The All Inclusive Omni package ships with the cameras already installed.
If you want to re-install a camera or if you have the Rig Only version of
Omni, follow the steps below.
1. Confirm that all cameras are HERO4 Black cameras. Other GoPros are
not supported.
2. Confirm that all cameras are using the same version of array firmware.
To obtain the latest array firmware for Omni, visit gopro.com/help
and log in to the Omni Support Hub. If you need to create a support
hub account, follow these instructions: https://community.gopro.
com/html/assets/GoProOmniSupportHub.pdf.
3. Complete these steps for each camera:
a. Use the included hex key to loosen (but not remove) the screws on
one of the panels.
b. Gently pull the panel off of the frame.
c. Connect a camera to the HEROBus connector on the inner cube.
d. Align the outer panel with the lens, then gently slide the panel onto
the lens and move the corners into place.