Instructions / Assembly

CATCH
ROD
CATCH
SLIDE
DO NOT ALLOW CATCH ROD TO
RUB ON THE HEADER AREA
NOTED HERE
BEND CATCH ROD
AT THIS POINT
IN DIRECTION
OF ARROWS
HEADER
3
CD INSTALLATION
STEP 1–ASSEMBLE FRAME STEP 2–ATTACH FRAME TO HOUSE
STEP 3– SLIDE ON DOOR PANELS STEP 4–INSTALL CATCH RODS
STEP 5– ALIGN AND ADJUST DOOR PANELS STEP 6–DRILL AND ATTACH FRAME
Use
1
/4 ” bolts and nuts from hardware package. Bolt heads
must face the outside of the door frame. Nuts on the inside.
NOTE: The sill bends toward the house.
Align frame on foundation and attach only at center hole
in header.
Align the door with the upper and lower pins. Slide door
bushing onto door pi
ns.
Install catch rods into catch slides. Adjust rods by bending
them slightly. Do not allow them to rub on the header.
Adjust frame and doors by moving them from side to
side until you find the point at which the doors will open
and close without binding.
Use prepunched holes in sides and sill as a guide, drill
holes onto the foundation 1
3
/4 ” deep using a
1
/4 ” masonry
bit. Install plastic rawl plugs and fasten with 1
1
/2 ” screws
until snug. Check door alignment again. Over tighteni
ng
will cause misalignment.
Bolt Head