Dear customer! This electric integrated gas hotplate cooker is manufactured for household use. Our appliances are packed in the environmentally friendly materials which may be recycled, deposited or destroyed without any hazard to the environment. Such packaging materials are also labeled accordingly. Once the life cycle your appliance is over, make sure not to pollute the environment, and deliver it to the authorized collectors of old household appliances.
TECHNICAL INSTRUCTIONS AND INSTALLATION Important warnings • Installation of the appliance (installation class:3) into a kitchen worktop and its connection to the power mains and the gas supply may only be performed by an adequately qualified technician. • When the appliance is in use, additional heat and moisture are emitted into the room.
INSTALLATION Important warnings This appliance must be installed by an authorised person in accordance with this instruction manual, AS/NZS 5601 – Gas installations (installation and pipe sizing), local gas fitting regulations, local electrical regulations, local water regulations, local health regulations, Building Code of Australia and any other government authority.
A (mm) B (mm) C (mm) D (mm) E (mm) F (mm) G (mm) 585 510 560 480 40 5 50 Installing the foam gasket Before inserting the appliance into the opening in the kitchen worktop, the supplied foam gasket must be attached to the lower side of the glass ceramic (glass) cooking hob (see fi gure above). Do not install the appliance without the foam gasket! The gasket should be attached to the appliance in the following way: - Remove the protective film from the gasket.
consistent with the voltage in your home circuit. • The rating plate with basic information is attached on the lower side of the hob. • The appliance is manufactured for use with the power supply voltage 220-240 V ~. • In order to make a fixed connection to the mains, insert an all-pole circuit breaker between the appliance and the mains. This device shall have a contact separation in all poles, providing full disconnection under overvoltage category III conditions.
Connection • When connecting the appliance to the gas supply, follow the regulations of the local gas distributor. • On the lower side, the cooking hob is fitted with a gas connection plug with a ISO7-1 R1/2 thread. • Also supplied with the appliance is an adapter for liquid gas, a taper male, and a nonmetal gasket. • When connecting, the knee R1/2 should be held firmly to prevent it from rotating. • For sealing of the connection joints, use a non-metal approved gaskets and approved sealants.
Adaptation to a different type of gas • The procedure or adaptation of the cooker to another type of gas does not require removal of the appliance from the worktop. • Before adapting, disconnect the appliance from the power mains and close the gas supply valve. • Replace the existing nozzles for nominal thermal load with corresponding nozzles for the new gas type and supplied provided (see table below).
NOZZLE TABLE Burner Rated heat output (MJ/h) Reduced Rate (MJ/h) Ø INJECTOR (mm) Universal LPG Natural gas Ø BY-PASS (mm) Universal LPG Natural gas Important warnings A 3,60 1,62 SR 6,30 2,52 MW 11,88 5,40 0,50 0,90 0,65 1,20 0,85 1,60 0,27 REG. 0,34 REG. 0,55 REG. • The gas burners are fitted a candle as flame failure device. If the burner flame is extinguished accidentally or unintentionally (e.g.
INSTRUCTIONS FOR USE AND MAINTENANCE OPERATION Hob control elements Gas valve closed Ignition Maximum power Minimum power Ignition and operation of the burners User’s instructions This appliance must be used for the purpose it was designed for, i.e. domestic cooking. Any other use is considered to be improper and therefore dangerous. The manufacturer will accept no liability for any damage caused by improper, incorrect or irrational use.
CLEANING AND MAINTENANCE Do not use a steam cleaning appliance to clean this appliance. The steam could reach the electrical components and cause a short circuit. The appliance should be cleaned regularly, preferably after each use, after cooling down. To avoid water marks and limescale deposits, use a soft cloth to dry surfaces that have been cleaned with water. Food that has boiled over can cause discolouration of the burner parts and the stainless steel cooktop. Remove any soiling immediately.
Ceramic glass surface After each use of the glass-ceramic hob, wait for it to cool down and clean it; otherwise, even the smallest food residue will be burnt onto the hot surface next time you use the appliance. For regular cleaning and maintenance of the glass-ceramic surface, use special conditioning agents which form a protective layer on the surface, shielding it from dirt.
PROBLEM SOLVING GUIDE Important ▪ During the warranty period, only a service center authorized by the manufacturer may carry out any repairs. ▪ Before making any repairs, make sure the appliance is disconnected from the power mains either by removing the fuse or by disconnecting the power plug from the wall outlet. ▪ Unauthorized tampering with and repairs of the kitchen range (cooking hob) can result in electric shock or short circuit; hence, do not attempt to perform any repairs by yourselves.