User Manual

4
INSTALLATION
Important warnings
This appliance must be installed by an authorised person in accordance with this instruction manual, AS/NZS 5601 –
Gas installations (installation and pipe sizing), local gas fitting regulations,
local electrical regulations, local water regulations, local health regulations, Building Code of Australia and any other
government authority.
• Installation of the appliance into a kitchen worktop and its connection to the power mains may only be performed by an
adequately qualified technician.
• Veneer or other finish of the piece of kitchen furniture into which the hob is to be built in should be treated with heat
resistant glue (100°C); otherwise, the worktop finish may be discolored or deformed.
• Cooking hob is dimensioned to be built into the worktop over a piece of kitchen furniture, with a width of 600 mm or
more.
• After installation, the front two fastening elements should be freely accessible from below.
• The kitchen furniture element underneath the hob should not be fitted with a drawer. If the kitchen furniture element as
a horizontal partition wall, it should be installed no less than min 20mm from the lower surface of the worktop. The space
between the partition wall and the hob must be empty; no objects should be placed into that gap.
• Hanging, or wall-mounted kitchen elements should be installed high enough not to interfere with the work process.
• The distance between the cooking hob and the kitchen hood should be no less than indicated in the instructions for
kitchen hood installation. The minimum distance is 700 mm.
• The distance between the appliance edge and the adjacent tall kitchen furniture element should amount to no less than
150 mm.
• Use of massive wood decoration plates or boards on the worktops behind the cooking hob is permitted, if the minimum
distance remains the same as indicated in the installation drawings.
• Minimum distance between the built-in cooking hob and the rear wall is indicated on the installation drawing.
• Cooking hobs can be installed into worktops that are 25 to 40 mm thick.
The front part must have an opening of no less than 5 mm.
Overhead clearances—(Measurement A) Range hoods and exaust fans shall
be installed in accordance with the manufacturer’s relevant instructions.
However, in no case shall the clearance between the highest part of the hob of
the gas cooking appliance and a range hood be less than 600 mm or, for an
overhead exhaust fan, 750 mm.
Side clearances—(Measurement B & C) Where B, measured from the
periphery of the nearest burner to any vertical combustible surface, or vertical
combustible surface covered with toughened glass or sheet metal, is less than
200 mm, the surface shall be protected to a height C of not less than 150 mm
above the hob for the full dimension (width or depth) of the cooking surface area.
Where the gas cooking appliance is fitted with a „splashback“, protection of the
rear wall is not required.
Gas inlet is located at the rear right 25mm from the edge.