Technical data

237353

• Pull the power lead from the socket and cut the power supply

from the mains.

• By the user

After drying be careful when extracting laundry from the

appliance, as it may be hot!

Suspending the operation by pressing the START/PAUSE

button.

In case you press the START/PAUSE button (D) during the drying

procedure, the drying program is suspended, and with the next

press of the same button the program is resumed where it had

been interrupted.

Changing the program or the functions

If you wish to change the drying program or the additional

functions during the drying procedure, move button (A) to the

position “0”, select new drying program or additional functions and

conﬁ rm the new selection by pressing the START/PAUSE button.

Door opened

If the door is opened during the drying process this will pause

the operation. The (I) or (H) LEDs will ﬂ ash, depending on the

drying process stage. When the door is closed, the drying process

resumes only after the START/PAUSE button (D) is pressed. The

(I) or (H) LED stops ﬂ ashing.

• Power failure

If a power failure occurs during the operation of the dryer, ((I) or

(H) LED ﬂ ashes, depending of the drying process stage), press

the START (D) button to resume the program from where it was

interrupted (the LED stops ﬂ ashing).

• Water container is full

On a condensation dryer the (E) LED is on, indicating that the

water container is full, and the drying program is suspended

((E) and (I) or (E) and (H) LED’s are ﬂ ashing, depending on the

drying process stage). When the container is emptied, press

the START button (D) to reactivate the drying program. The (I)

or (H) LED is on again.

• Drum lamp

The drum is illuminated when the appliance door is open. If the

door is open for more than 5 minutes and no changes to the

settings have been made, the lamp goes off.

InterruptionsInterruptions

Special functionsSpecial functions