Operation Manual

252584
• Only type EVP4, EVP2... ovens fi tted with a cooling fan may
be installed underneath this cooking hob.
• Before installing an oven, the rear wall of the kitchen furniture
element should be removed in the area of the cooking hob
cutout. Furthermore, a gap of at least 6 mm should be left at
the front side.
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Attach the fastening elements (4) with the supplied screws (4)
to the front and rear wall of the cooking hob and the worktop
cutoff.
• Connect the cooking hob to the power mains and gas supply
(see instructions for connecting a cooking hob on a power
network and gas supply).
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.
• Attach the supplied adhesive seal on the lower edge of the
cooking hob.
• Insert the cooking hob into he cutoff and press it heavily from
above towards the worktop.
Installation procedureInstallation procedure
Type EVK6..
10