Operation Manual

Instructions for use, mounting and connection
48
Switching the extended hotplate
rings on (hotplates 2 and 4)
Switch the relevant hotplate ( 2 or 4) and
consequently switch the extended hotplate ring by
pressing the relevant sensor (see the control
element board illustration). The LED signal lamp
above the indicator displays the extended ring is
on. Now select the random heating power for
both hotplate rings together. Extended ring may
be switched off either by consequent pressing the
sensor or by reducing the heating power to "0",
as well as by simultaneous pressing of both the
(-) and (+) sensor. It may of course be switched
off also by switching off the entire hob.
Switching the second hotplate ring
on
The rear right hotplate (4) is equipped with the
extended hotplate ring, which is switched on by
pressing the special second ring sensor. The
signal lamp above the indicator displays the ring
is on.
Switching the third hotplate ring on
(certain models)
The front left hotplate (2) is equipped with two
extended hotplate rings. To switch the second
ring on, press the special second ring sensor (top
left). The LED signal lamp above the indicator
displays the ring is on. To switch on the third ring
press the same sensor once again, another LED
signal lamp is on. Both extended rings are
switched off by repeated pressing the sensor.
They may also be switched off by switching off
the relevant hotplate or the entire hob.
Blocking the hob operation
This function mode is intended as a protection
against accidental start or change of heating
power by children or pets. The hob may be
blocked by pressing the relevant sensor for about
3 seconds, illuminating the LED signal lamp
above the sensor. The hob may be blocked both
with the hob switched on or off. The functioning of
the complete hob is blocked, except for the main
hob switch and the blocking sensor. In the
blocked mode all hotplates may be switched off
only by pressing the main ON/OFF hob sensor,
while the blocked mode remains active. To
activate a particular sensor in the blocked mode,
the signal lamp goes on for a few seconds. If a
particular hotplate is in timer automatic mode, the
countdown proceeds normally and the hotplate is
switched off at the expiry of preset time, signaling
the end by the triple beep.
The blocked mode may be switched off at
anytime by pressing the sensor. Short beep
confirms the action, and the LED signal lamp
goes off.