Operating Instructions and Installation Instructions

436556

‘’ The appliances are suitable for photovoltaic electrical

power under the condition that electrical voltage will

be 220VAC - 240VAC with semi tonic frequency 50Hz

in order the appliance to operate properly (alternative

a generator can be used with the same technical

characteristic).’’

• Incorrect connection may destroy parts of the appliance,

making the warranty void.

• Before connecting the appliance, make sure the voltage

indicated on the rating plate is consistent with the

voltage in your home network. Connection voltage

(230 V through N) should be checked by a qualiﬁ ed

technician using a corresponding measuring device!

• Connection cable on the back of the appliance should

be led in such way that it does not touch the appliance

back wall, as this part will get very hot during operation.

NOTE:

Connection bridges are already installed on their

respective places on the clip. Screws of the connection

terminals are open, which means they do not have to be

unfastened or unscrewed any further. When fastening the

screws, you may hear a slight ‘click’, which means that the

screws should be fastened / screwed in completely.

The following can be used for connection:

• Type H05 RR-F 4×1.5 rubber connection cables with a

green-yellow protective wire,

• Type H05 VV-F 4x1,5 PCV insulated connection cables

with yellow-green protective wire, or other equivalent or

superior grade cables.

Connection diagram