User Manual

Settings
Open the Settings menu:
First, open the door. Turn off the machine. Press and hold the main power switch until the display lights
up.
1.
Within 10 seconds:
- press the program button for Auto wash and the option button for SpeedWash.
2.
+
The display shows the Settings menu (current setting and its currently set value).3.
(Exit the menu by browsing through the menu or pressing the main power switch.)
Navigate the Settings menu:
Press to save the set value and continue to the next
setting.
Current setting.
Current setting value.
Press to browse between setting values.
You can now adjust the following settings:
OptionsSettings
Rinse aid dosage setting.1:00 - 1:05Rinse aid1.
Increase the rinse aid dosage:
•
If the dishes have water marks.
Decrease the rinse aid dosage:
•
If the dishes have a sticky white/blue film.
•
If the dishes are streaked.
•
Build-up of foam. If you have very soft water, the
rinse aid can be diluted 50:50 with water.
The dishwasher uses a buzzer to indicate when a pro-
gram is finished or when a fault has occurred.
4:00 - 4:03Buzzer volume4.
Self-cleaning program for antibacterial cleaning of the
dishwasher tub, spray arms and spray pipes.
5:00 (Off)
5:01 (On)
Self Cleaning Program5.
This program can be run (with no dishes in the machine)
using normal dishwasher detergent, citric acid or one
of the dishwasher cleaners available on the market. For
the removal of limescale deposits, see also the section
Limescale deposits in the chapter Care and cleaning.
Start the program by activating the setting and then
closing the door.
8