Installation Instructions

ManualsBrandsGorenje ManualsCooling Freezingki 232 la 4

141886

Mounting Instructions10

Mounting Instructions

Integrated Refrigerator with

Freezer

Mounting instructions for refrigerating and freezing appliances are for

qualified technicians only.

Appliance should be mounted and installed in compliance with these

instructions, current standards and regulations.

Mounting instructions were prepared for various types/models of

appliances, therefore they may describe some procedures that do not

apply to your appliance.

Mounting Dimensions and

Required Air Circulation 11

Changing the Direction of

Opening the Door 12-13

Mounting the Appliance 14-15

Summary of content (6 pages)

PAGE 1
41886 Mounting Instructions Integrated Refrigerator with Freezer Mounting instructions for refrigerating and freezing appliances are for qualified technicians only. Appliance should be mounted and installed in compliance with these instructions, current standards and regulations. Mounting instructions were prepared for various types/models of appliances, therefore they may describe some procedures that do not apply to your appliance.
PAGE 2
141886 Mounting Dimensions and Required Air Circulation The rear wall of the appliance is getting warm during the operation of the appliance and water is evaporating from the drain pan on the compressor. You must therefore provide for adequate air circulation on the rear of the appliance. • At the base of the kitchen unit intended for building in the integrated appliance, there should be at least 200 cm² free space, for adequate air circulation.
PAGE 3
141886 Reversing the door opening If you find the door opening direction of your appliance inconvenient, you can reverse it. The necessary holes on the opposite side of the appliance cabinet have been made in the factory and plugged. • Remove the top hinge cover of the refrigerator door. Remove the door by unscrewing the hinge (the door is supported only by the bottom hinge) and remove the hinge washer. • Unscrew the top strip, move it on the opposite side of the appliance and fasten it.
PAGE 4
141886 1 Top hinge cover of the refrigerator door 2 Top hinge of the refrigerator door 3 Top strip 4 Bottom hinge of the refrigerator door 5 Top hinge of the freezer door 6 Washer 7 Bottom hinge of the freezer door 8 Bottom hinge filling plug of the freezer door 9 Slider guide 10 Corner cap with a hole 11 Corner cap without a hole Mounting Instructions 13
PAGE 5
141886 Mounting the Appliance • Push the appliance for some 38 mm into the kitchen unit and allow at least 4 mm free space on both sides between the appliance and the side walls of the kitchen unit (Fig. 1). • Widely open both the doors and put them together with the door of the kitchen unit. The procedure is as follows: − Fix the slide guides (attached in a plastic bag along with the screws ST 4,2 x 9,5) to the edge of the door. Cover the open holes with the attached cap.
PAGE 6
141886 Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig.