Installation Instructions

6
1 Cover for the upper hinge
2 Upper hinge
3 Upper rail
4 Slide guide
5 Lower hinge washer
6 Lower hinge fastener
7 Lower hinge
8 Corner without a hole
9 Corner with a hole
10 Low temperature compartment
11 Blocking element
12 Door hinger
Mounting the Appliance
Push the appliance for some 38 mm into the kitchen unit and allow at least 4 mm free space on both
sides between the appliance and the side walls of the kitchen unit (Fig. 1).
Widely open both the doors and put them together with the door of the kitchen unit. The procedure is
as follows:
Fix the slide guides (attached in a plastic bag along with the screws ST 4,2 x 9,5) to the edge of the
door. Cover the open holes with the attached cap.
Put together the appliance door and the door of the kitchen unit (Fig. 2).
Insert the slides into the guides and fi x them on the kitchen unit door some 15 mm from the edge, using
the A 4 x 12 screws (Fig. 3).
Remove the slide guides and separate the appliance door from the door of the kitchen unit.
Fix the slides and be careful not to move them while fi xing (Fig. 4).
Fix the slide guides to the original position.
Close the door and check the gasket (it should not be creased). The door should open and close
smoothly.
NOTE:
Appliance with the height of 575 mm have only one slide and one slide guide.
Fix the appliance into the kitchen unit. On the upper side, fi x the three screws A 4 x 12 through the rail
and on the lower side with two screws A 4 x 16, through the lower hinges. Drill holes, ø 3 x 5 (Fig. 5).
Seal the gap on the opposite side of the hinge with the enclosed seal (Fig. 6).
WARNING
Before mounting the appliance into the kitchen unit, disconnect the power supply and set the thermostat
knob to STOP (0) position or switch off the ON/OFF switch.
L’istruzioni per l’installazione degli apparecchi frigoriferi - congelatori sono scritte per i tecnici.
L’installazione e collegamento dell’apparecchio devono essere eseguiti in conformità alle norme e pre-
scrizioni vigenti. L’istruzioni si possono usare per diversi tipi/modelli degli apparecchi perciò è possibile
che descrivono i procedimenti non necessari per il vostro apparecchio.
Misure d’ingombro e raffreddamento apparecchio
L’apparecchio deve essere installato al modo di permettere la circolazione libera dell’aria. La parte poste-
riore si riscalda durante il funzionamento e l’acqua del contenitore sul compressore evapora.
•
•
•
•
•
•
•
•
•
•
•
III.
I.
Apparecchi frigoriferi-congelatori integrati IT