Operation Manual

Instructions for Use
18
Do not eat frozen food (bread, fruit, vegetables), because you
can get frostbites.
If the food has strange smell or color, throw it away, because it is
very likely that it is spoiled and therefore dangerous to eat.
Shear-type hinge (only on some models) enables automatic door
closing at the opening angle of 20°. On account of strong springs
take care when handling the door.
The bag with instructions also contains squares and sponges,
intended for installation of integrated appliance with shear-type
hinge, as well as plastic caps for covering of hollow spots on
walls inside the appliance.
Disconnect the appliance from the power supply before
repairing it (only a qualified technician should repair it), before
cleaning and before replacing the light bulb.
Do not defrost the appliance with other electric appliances (as for
example with hair dryer) and never scrape the frost layer with
sharp objects. Use only enclosed tools or tools recommended by
the manufacturer.
For the sake of environment protection - be careful not to
damage the rear wall of the appliance (the condenser unit or the
tubes - for example when moving the appliance) or any part of
the refrigerating system inside the appliance.
The refrigerating system of the appliance is filled with refrigerant
and oil, so when the appliance is damaged, handle it with care
and dispose it of in compliance with environmental protecting
precautions. (See We Care for the Environment).
If the supply cord is damaged, it must be replaced by the
manufacturer or his service agent or a qualified person in order to
avoid hazard.
The rating plate is inside the appliance or outside on the rear
wall.
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of thisproduct. For more detailed information
about recycling of this product, please contact your local city
office, your household waste disposal service or the shop
where you purchased the product.
Disposing of the Worn Out Appliance
When your appliance finally wears out, dispose it of. If the
appliance has a lock, break it, in order to prevent eventual
accidents (danger of children get locked inside the appliance).
The refrigerating system of the appliance is filled with refrigerant
and insulating substances which should be separately treated
and processed. Call your nearest authorised service agent or
specialised servicing centre. If you don't find one, contact your
local authorities or your distributor. Be careful not to damage the
tubes on the rear wall of the appliance (danger of pollution).
Placing and Installation
Choosing the Right Place
Place the appliance in dry and regularly ventilated room. Allowed
ambient temperature depends on the model (class) of the
appliance and is stated on the rating plate of the appliance. Never
place the appliance near heat emitting devices (e.g. cooker,
radiator, water heater or similar devices) and do not expose it to
direct sunlight. The appliance should be positioned at least 3 cm
away from the electric or gas cooker and at least 30 cm away from
the oil or coal stove. If this is not possible, use an appropriate
insulation. Behind the appliance there should be free space at least
200 cm² wide and above the appliance the high kitchen units
should be at least 5 cm away from the appliance in order to assure
adequate ventilation of the condenser unit.
Class Ambient temparature
SN (sub-normal) from + 10°C to + 32°C
N (normal) from + 16°C to + 32°C
ST (sub-tropical) from + 16°C to + 38°C
T (tropical) from + 16°C to + 43°C
Connection to Power Supply
Connect the appliance with the cable and plug to the power supply
socket outlet with a ground terminal (safety socket).
Required nominal voltage and frequency are indicated on the rating
plate. The connection to the mains supply and earthing have to be
made according to current standards and regulations. The
appliance resists temporary voltage tolerance up to -6 to +6 %.
Description of the Appliance