Operation Manual

EN
7
Dear buyer, we thank you for purchase of our product.
PRIOR TO INSTALLATION AND FIRST USE OF THE ELECTRIC WATER HEATER,
PLEASE CAREFULLY READ THESE INSTRUCTIONS.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN)
WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF
EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION
OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY PERSON RESPONSIBLE
FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH
THE APPLIANCE.
This water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the Safety Certifi cate and the
Electromagnetic Compatibility Certifi cate. The technical characteristics of the product are
listed on the label affi xed between the inlet and outlet pipes. The installation must be carried
out by qualifi ed staff. All repairs and maintenance work within the water heater, e.g. lime
removal or inspection/replacement of the protective anticorrosion anode, must be carried out
by the authorised maintenance service provider.
BUILDING-IN
The water heater shall be built-in as close as possible to the outlets. When installing the
water heater in a room with bathtub or shower, take into account requirements defi ned in IEC
Standard 60364-7-701 (VDE 0100, Part 701). It has to be fi tted to the wall using appropriate
rag bolts with minimum diameter of 8 mm. The wall with feeble charging ability must be
on the spot where the water heater shall be hanged suitably reinforced. The water heater
may be fi xed upon the wall only vertically. We recommend the distance between the water
heater and the ceiling is large enough to allow simple replacement of the MG anode (see
dimension G in the Installation Drawing), in order to avoid unnecessary dismounting of the
heater during the servicing intervention.
TECHNICAL PROPERTIES OF THE APPLIANCE
Type TGR 30 N TGR 50 N TGR 80 N TGR 100 N TGR 120 N TGR 150 N TGR 200 N
Model TGR 30 N TGR 50 N TGR 80 N TGR 100 N TGR 120 N TGR 150 N TGR 200 N
Volume [ l ] 30 50 80 100 120 150 200
Rated pressure [ MPa] 0,6
Weight / Filled with water [ kg ] 20/50 24/74 30/110 34/134 38/158 44/194 70/270
Anti-corrosion protection of tank Enameled / Mg Anode
Connected power [ W ] 2000
Voltage [ V~ ] 230
Heating time to 75°C
1)
[ h ] 1
05
1
55
3
05
3
55
4
35
5
45
7
40
Quantity of mixed water at 40°C [ l ] 50 89 145 200 236 298 399
Energy consumption
2)
[kWh/24h ] 0,90 1,32 1,85 2,20 2,60 3,20 2,80
1) Time for heating of the whole volume of heater with electric immersion heater by entering temperature of
cold water from water supply 15°C.
2) Energy consumption to maintain stable temperature of water in the water heater 65°C at surrounding
temperature 20°C, measured according to EN 60379.