Instructions for Use Washing machine
Thank you for your confidence in purchasing our washing machine, and congratulations on the excellent choice. Your new washing machine meets the requirements of modern treatment of laundry. It is rational in the consumption of energy, water and washing agents. Our appliances are friendly to the environment. Some of the materials may be recycled, others deposited or decomposed. To avoid pollution of environment, once your appliance is no longer useful, take it to your local authorized waste appliance dealer.
Description of washing machine Technical information (depending on model) 5. Adjustable legs 6. Water outlet hose 7. Water inlet hose 8. Mains power cable Dimensions (w x d x h): 600 mm x 600 mm x 850 mm Dimensions (w x d x h): 600 mm x 440 mm x 850 mm Depth with door open: 106 cm / 88 cm (depending on model) Weight (net): 90 kg / 79 kg (depending on model) Nominal voltage: 230 V, 50 Hz Power: 2300 W / 2000 W (depending on model) Max.
Cautions • Be sure to remove transport brackets prior first use of the appliance. Attempted operation of the blocked machine may result in irreparable damage which is not covered by the manufacturer’s warranty! • When connecting your washing machine to water supply, be sure to use brand new water inlet hose and appropriate sealing gaskets (attached). • Do not locate the machine in a room with temperature below 0°C. Parts of the machine may be damaged if frozen.
Installation and connection Package removal In removing the wrapping be careful not to damage the appliance with a sharp object. Before connecting the appliance, let it warm up to room temperature (wait for two hours). • Our appliances are packed in environmentally friendly materials which may be recycled, deposited or decomposed without any threat to the environment. • To this end all wrappings are marked accordingly. Removal of transport brackets • Move the pipes.
• If you have a tumble dryer of the same dimensions, you can place it on top of the washing machine. Water inlet connection To ensure correct operation of the appliance, water pressure inlet must be between 0,05 and 0,8 MPa. Minimum water pressure can be established by measuring the quantity of poured out water. 3 litres of water must be poured out from completely opened tap in 15 seconds.
Water outlet connection • Fix the outlet hose to run into the sink or the bathtub, or connect it directly to the wall drain outlet (diameter min. 4 cm). • Wall drain must be installed properly and must enable occasional cleaning. • Fasten the outlet hose support with a piece of rope led through the hose elbow, to prevent the hose from slipping to the floor. The end of outlet hose should be placed between minimum 60 cm and maximum 100 cm above the floor level.
Operation A - program selector B - lower spin RPM or spin off knob (depending on the model) C - Short or half program knob (depending on the model) D - elevated water level knob E - pump stop knob F - START/PAUSE knob Program selector Signal LED’s: - washing program stages • wash • rinse • spin - Child lock Basic programs Cotton Pre-wash Heavy duty Easy iron Rinse Synthetics Pre-wash Softening Delicate Pumping water Wool Spinning Manual wash Mix 141373 8 Partial programs
Washing procedure • • • • • • • Open the door of the machine. Load the laundry into the drum. Close the door. Open the water inlet faucet. Push the ON/OFF button and select the program. Add washing and treatment agents (detergent and softener). Start the operation by pushing the START knob (F). - Open the door of the machine. Door is opened by pulling the handle (lever) on the right hand side of the door towards you. - Sort the laundry by the type of fabrics.
cloth, bathroom towels, top garments, etc. For heavily stained permanent press use the heavy duty or program with the pre-wash . program, If you wish the laundry not to be excessively creased at the end of washing, use easy ironing program . Synthetics Normally stained shirts, blouses and other polyester and polyamide garments, or a mixture of these fabrics with cotton. For heavily stained permanent press use program with pre-wash .
• • • • during the operation, prior last rinse. Indicator LED above the washing cycle symbol is lit. The program stops at the end of last rinse, prior spinning: laundry remains soaked in water and prevents crease, if you are unable to remove it from the drum immediately after the end of washing cycle. Indicator LED above the knob is flashing.
- Selection of partial programs ( , , , ) These are independent programs and may be used when you do not need the entire washing program. In case you would like to use more additional programs in a sequence, you must turn off the appliance prior any new program selection (turn the program selector to “0” for at least one second). Rinse Independent program for rinsing delicate laundry, without intermediate spinning and with short final spin. You may use it for rinsing manually washed delicate laundry.
Start the operation • Push the START button (F). Sound signal confirms the start, the LED indicating particular washing stages stops flashing. The machine starts operating after a few seconds. If the door is not properly closed after starting the operation, the washing stage indicator LED starts flashing again after a few seconds. When you close the door, the machine initiates the selected program.
PAUSE knob By pressing the PAUSE knob (F) program may be suspended at any time. After certain time you may open the door if there is no water in the drum, otherwise this is not possible. Program is continued by pressing the START knob (F). • Failures Program is suspended in case a failure occurs. Signal LED’s are flashing and sound signal is heard (see cf. Failures).
Tips for washing and energy saving • Before washing sort out the laundry according to the type, degree of dirtiness and color resistance. • Prior selecting the washing program consult the sewn tab with information on a particular piece of laundry (see Maintenance Chart on the last page). • Wash separately the new colored textile products for the first time. • Wash heavily soiled laundry in small quantities and add more detergent. • Treat stubborn stains with special stain remover, it will save energy.
• Insert particularly delicate linen (stockings, delicate female underwear, etc.) into the special bag. • High spin RPM leave less moisture in laundry which dries out much quicker in the tumble dryer, thereby saving energy. Do not put clods of detergent into the soap dispenser as the tube in the washing machine may clog. Cleaning and maintenance Disconnect the washing machine from the mains before cleaning! • The casing should be cleaned with soft cloth and mild detergent.
• Wash it under running water using a brush, and dry it. Remove any leftover dried detergent from the bottom of the casing. • Clean the entire rinsing area of the washing machine with a brush, especially the nozzles on the upper side of the rinsing chamber. • Clean frequently the water inlet hose screen under running water. • After each wash wipe the door rubber gasket. This will prolong its useful life. • Open the filter lid using flat screwdriver or similar tool.
• Insert the filter back as shown on the picture (arrow and pointer), and tighten by turning it in clockwise direction. To ensure good sealing the gasket surface (A) must be dirt free. Failures The washing machine automatically monitors the execution of particular functions during the operation, and reports any detected failures. In such cases both signal LED’s start flashing in certain sequence, accompanied by the audible signal, sounding in the same sequence as the indicator LED’s flash.
Possible cause Remedy The machine does not work (indicator LED’s are not illuminated). Machine is not powered. Check if: • power in the socket, • the fuse is OK, • plug is in the socket. Washing program does not start (washing stage LED is flashing). Door is not properly closed. Push it towards the machine. Water does not enter the machine (after approx. 8 min the machine reports failure -3 flashes). Disturbed water inlet. Check if: • the water faucet is open, • inlet pipe net filter is clean.
Failure Possible cause Remedy Laundry is stained after washing. You used liquid detergent or detergent for colored laundry which does not contain whitener. Use the detergent containing whitener. White powdery residues on the laundry. It is not the consequence of bad rinsing, but because of neophosphate detergents containing non soluble components (zeolites) for water softening. Such substances may be deposited upon the laundry. Immediately rinse the laundry once again.
Tables Program chart - 7 kg RPM RPM 1000 - 1400 Energy cons.
Program chart - 6 kg 1000 - 1400 Cotton 6 95 139 63 58 51 2,30/2,10** 2,10/2,05** Cotton 6 60 119 57 52 45 1,28/1,12** 1,12/1,00** Cotton + prewash 6 60 150 65 60 53 1,50/1,34** 1,34/1,22** Cotton - heavy * 6 60 140/150** 57 52 45 1,30/1,14** 1,14/1,02** 1400 400 - 700 800 - 1400 800 - 900 RPM 400 - 700 RPM Duration (min.) Energy cons. kWh Temp. (°C) Water cons. L Max. load Spin (max.
Water cons. L 4,5 95 140 47 40 1,80 Cotton 4,5 60 122 44 37 0,82 Cotton + prewash 4,5 60 147 49 43 0,99 Cotton - heavy * 4,5 60 145 44 37 0,85 Cotton 4,5 40 121 44 37 0,51 Cotton - easy ironing 2 60 Synthetics 2 60 Synthetics max. 1400 max. 1000 800 - 900 1000 - 1400 Cotton Spin (RPM) Temp. (°C) RPM Max. load (kg) Duration (min.) Basic programs Energy cons.
z z z z z z z/z Cotton heavy z z z z/z Cotton z z z Synthetics with pre-wash z z z Synthetics z z z z z/z Delicate z z z z/z Wool z z z z/z Manual wash z z z Mix z z z z z/z z/z z/z z z/z Partial programs Rinse z/z Softening z/z Pumping water Spinning z possibility 141373 24 z/z OFF Short program z Cotton with prewash water level Cotton Basic programs Pump stop Halfprogram Program Reduced spin RPM / spin Higher Program chart/Additional fun
Maintenance chart Normal wash Max. washing temp. 95°C Delicate wash Whitening Max. washing temp. 40°C Max. washing temp. 60°C Whitening in cold water Max. washing temp. 30°C Manual washing Washing not allowed Whitening not allowed Ironing Hot iron max. 200°C Hot iron max. 150°C Hot iron max.
141373 26
PS PG2 141373/en (02-08)