Instructions / Assembly

TARP BOARD FOR THE

PAN HEAD SCREWS.

NOTE: IF YOU WISH

YOU MAY DRILL 1/8"

PILOT HOLES IN THE

TARP 47-3/8" X 105"

(COLOR AND STYLES

MAY VARY)

THEN FOLD

THIS TAB UNDER

THE TARP BOARD

AND SECURE IT

TO THE BOTTOM

SIDE OF THE TARP

BOARD WITH

#14 X 1-1/4"

PAN HEAD SCREWS

AND 1/4" WASHERS.

REPEAT FOR OTHER

SIDE.

FASTEN OUTSIDE GROMMETS FIRST TO

THE SIDE OF THE TARP BOARD ON

EACH SIDE WITH #14 X 1-1/4" PAN

HEAD SCREWS AND 1/4" WASHERS.

REPEAT FOR OTHER SIDE.

STEP 29: TARP

1: PLACE THE 47-3/8" X 105" TARP ACROSS THE TARP BOARDS WITH THE HEMS ON THE INSIDE.

2: FASTEN THE OUTSIDE CORNERS OF THE TARP TO THE SIDE OF THE TARP BOARD FIRST. ATTACH THE GROMMETS

IN THE TARP TO THE TARP BOARDS WITH #14 X 1-1/4" PAN HEAD SCREWS WITH 1/4" WASHERS. REPEAT FOR OTHER

SIDE. (NOTE IF YOU WISH YOU MAY PREDRILL HOLES FOR THE PAN HEAD SCREWS WITH A 1/8" DRILL BIT.)

3: NOW FOLD THE FLAP UNDER THE TARP BOARD ON AND FASTEN THE GROMMETS UNDER THE TARP BOARD WITH

#14 X 1-1/4" PAN HEAD SCREWS WITH 1/4" WASHERS. REPEAT FOR OTHER SIDE. (NOTE IF YOU WISH YOU MAY

PREDRILL HOLES FOR THE PAN HEAD SCREWS WITH A 1/8" DRILL BIT.)